Experience in two-stroke piping system design and various components of two-stroke engines according to the international standards such as ISO,JIS,Etc.- Proficient in routing of various drain, lubrication, and fuel pipes.- Worked on the design of fuel oil & fuel oil heating systems for engines with different bore sizes and fuel types.- Knowledge of design of various types of welded supports and welded pipes.- Currently involved in the design and drafting of various engine components.- Developed equation-based parametric models for engine components including pistons, piston rods, and piston crowns.- clearance analysis for large assemblies.- Worked on the drawing of various combustion chamber components such as piston crowns and cylinder frames.- Created Bill of Materials (BOM) using Teamcenter.- Classified various standard components within Teamcenter.- Possess strong knowledge of the release process and action codes in Teamcenter.- Designed systems for lubrication, fuel oil supply, fuel oil heating, cylinder lubrication, fuel oil drainage, and other drainage systems for two-stroke marine engines.

During my internship at IGTR, I worked extensively on the design of die casting dies and press tools. I used Unigraphics NX for designing these tools, applying precise calculations to achieve optimal results.● Created and released detailed machining drawings to guide the manufacturing process for various components of die casting dies.● Prepared pre-machining drawings, establishing initial specifications and sketches for machining activities.● Created 3D models of various casting components.● Created sample inspection reports to ensure quality standards and specifications.● Organized assembly trees for die & Press tool assemblies, structuring components in a hierarchical format for streamlined assembly.● Interference analyses between components in die assemblies to identify and resolve potential conflicts.● Generated parting surfaces for casting components, designing mold separation surfaces.● Core cavity Extraction for casting components.● Created Strip Layouts for progressive dies to ensure maximum usability of raw material.

During my internship at Cummins Generator Technologies, I contributed to the development of vendor processes in the Quality Department:● Developed Pictorial Standard Operating Procedures (SOPs):- Created detailed SOPs for the assembly of various components of stators and rotors, enhancing assembly accuracy and consistency. ● Created Failure Mode and Effect Analysis (FMEA) charts:- Generated FMEA charts and action plans to address potential failures, based on severity, occurrence, and detection at different assembly stages. ● Designed Plant Layouts:- Planned the arrangement of machines to optimize the sequence of operations, minimizing material handling and worker movement.● Created Pictorial Tool List:- Developed visual lists of tools needed for the assembly of stators and rotors to streamline the process.● Created SOPs for the inspection of Incoming Material:- Created standard procedures for inspecting raw materials to ensure quality before use.● Developed Process Flow Charts:-Designed comprehensive flow charts outlining the entire assembly and quality testing processes for stators and rotors.