working as a instrumentation & control engineer specialist at Saudi Electricity Company Jeddah south thermal power project(oil fired) (4 *723 MW) in Saudi ArabiaDeveloping and implementing control system in DCS(yokogawa) and field side activitiesExpertise in troubleshooting,maintenance,annual shutdown activities/start up, and technical support for all control system in plant.conducting comprehensive troubleshooting and maintenance of systems,ensuring minimal dowmtime and optimal performancePerforming unit trip analysis and alaram/events managment. Manage and supervise DCS/PLC & related Cabinets maintenance, Troubleshooting,Instrument Calibration & Installation Transmitters like Pressure, Differential Pressure, Level, Flow fordifferent process lines, Preparation and presentation of the progress reports in the review meetings Good knowledge of hazardous areas classification, equipment selection and installation and maintenance practices of electrical equipment’s and Provide guidance for safe work practices and personal protective equipment’s (PPE)

• Ensuring the quality of both work and items by field inspection, review of drawings and instructing the laborers• Supervised all the electrical works from testing and commissioning• Planning of daily site construction activities. Optimize utilization of manpower and equipment. Meeting the client to take their feedbacks and suggestions• Preparation and presentation of the progress reports in the review meetings Good knowledge of hazardous areas classification, equipment selection and installation and maintenance practices of electrical equipment’s and Provide guidance for safe work practices and personal protective equipment’s (PPE

 Commissioning of STG/BOP/Boiler/ESP/FGD, Review of P & ID and Vendor documents, Review of Logic( permissive, protection, sequence ), Graphic, Instruments data sheet , I/O assignment and Instrument calibration,  Arrange Daily TBM, Managing Labor’s, Monitoring and Following the Work schedule, Full effort to finish the work before the schedule period, Manage and supervise DCS/PLC & related Cabinets maintenance, Troubleshooting, Instrument Calibration & Installation Transmitters like Pressure, Differential Pressure, Level, Flow for different process lines, Installation of Limit Switches, Accessories and Orientation check for Motor Operated Valves, Control Valves in Water, Steam, and Oil pipe lines, Commissioning and Troubleshooting the Transmitters, Analyzers, Rotork and Auma MOVs, RTDS, Thermocouples, Pyrometer, Furnace CCTV Camera , Vibration Sensors and Profibus communication type MOVs , Detail Software Engineering in Open and Close loop controls of all Function area in Power block and BOP area, Loop Checks (Hart and Field bus protocols) and Function test in control systems like SPPA-T3000, YOKOGAWA centum VP, Bentley Nevada 3500, SKF Vibration monitoring system and G.E Mark VIe for the Cold Commissioning and assistance during Hot Commissioning & Commissioned maintenance of PLC based Soot Blowers, Water Treatment plant, Hypo Chlorination, & CPP,h2 plant And in the execution of Site Acceptance Test for the final handover of the projects, regarding I&C part,  Involved in the testing and commissioning of instruments related to boilers like Soot Blowers, Flame Scanners, Boiler Tube Leak Detectors, Burners, Transmitters, All type of Valves and Burner Management Systems, Involved in the commissioning activities like Motor solo tests, Pump load tests, Event interlock tests, Initial firing, Steam blowing, Lube oil flushing, Turbine rolling and synchronization, Preparation of the Documents for Functional test records with respect to Logic