CNC Maintenance

As a maintenance Engineer, I draft maintenance plan, records maintenance activities and organise preventive and corrective maintenance on equipment on site.

In charge of all Electrical maintenance and Electrical set up for Belmet 7. Pre heat treatment on the Kwame Nkrumah FPSO January 2018. Turret Remediation Project (TRP).Supported and assisted in the connection and inspection of the power system for the KNK TRP. Supported and assisted in the testing and inspection of the jack up system for KNK TRP. Reading of electrical blueprints and performing layouts for electrical circuitry and devices.Identifying all tools required for tasks, identifying safety risks and the precautions required to eliminate those risks.Installation and termination of electrical system including bending and installing rigid conduit.Interpreting electrical schematic diagrams and repair faulty electrical equipment.Performing test on both LV and HV electrical component.Performing maintenance on Lincoln Electric DC 400, DC 655, Flex Tec 450, Flex Tec 500, Davi Plate Rolling machine, Koike CNC Plate cutting machine, 5”, 7” and 9” Angle grinders and SDMO generator set.

In charge of Subsea 7 site electrical network set up, maintenance and preparation of Electrical flying leads. Reading of electrical blueprints and performing layouts for electrical circuitry and devices.Identifying all tools required for tasks, identifying safety risks and the precautions required to eliminate those risks.Installation and termination of electrical system, including bending and installing rigid conduit.Interpreting electrical schematic diagrams and repair faulty electrical equipment.Performing test on both LV and HV electrical component.Performing maintenance on Lincoln Electric DC 400, DC 655, Flex Tec 450, Flex Tec 500, Davi Plate Rolling machine, Koike CNC Plate cutting machine and SDMO generator set.

Protection and Control Section: - Performing insulation resistance test and transformer ratio test before the transformer is connected to the grid.Performing earth resistance test.Underground cable fault tracing with the ECG test van.Substation Maintenance Section:- Maintenance of transformers, Overhead lines and underground cables.Control Operation Section:- Performing isolations on both LV and HV lines.Monitoring and operating under supervision the SCADA in the ECG control room. Projects Section:- Preparing requisition for material of ECG projectsInstallation of both LV and HV electric poles, installation of industrial and domestic energy meters.

Installing electrical component for motor starters, example Direct on line, forward and reversed and Star delta starters of electric motors. Performing maintenance and repairs on electric motors. Cable laying and termination. Changing of fluorescent tubes and units.

Installing electrical component for motor starters, example Direct on line, forward and reversed and Star delta starters of electric motors. Performing maintenance and repairs on electric motors. Changing of fluorescent tubes and units.