Activities:• Keep and maintain KPI (Customer DPPM, OBA, Supplier DPPM, Scrap)• Develop procedures and work instructions • Supplier Audits Extra Activities:• Responsible for Metrology and Calibration area.• ISO 14001:2015 Auditor

Activities: • Develop test method validation • Keep update the Quality Plan • Document Validation ProcessExtra-Activities:Provide couching to Incoming Inspection,Operation Quality and EngineeringGoals done:• Successfully qualify clean room and gowning area.• Successfully qualify laundry cycle.• Successfully implement the test method validation procedure.

Activities by Area:Molding Area - First article dimensional approval. - Gage R&R study. - Mold Qualify - CPK Analysis - Create inspection Sheets - Program CMM inspection routines - Support production and engineering - Training inspectors and quality technicalMRB Area- NCMR Control.- Material Disposition.- MRB Meetings Calibration Area- Coordinate calibration equipment’s- Keep up date calibration data base Incoming Inspection Area- AQL Audit.- Dimensional Inspections- Coordinate RTV

Metrology Area -First article dimensional approval. -Gage R&R study. -Follow up daily work plan -CPK Analysis-Create inspection work instruction -Program CMM inspection routines -Attend internal audits-Audit external metrology supplier-Support production and engineering -Keep update MFT metrics-Buy new equipment according inspection process.Calibration Area-Coordinate calibration equipment’s-Repair measurement equipment plant-Attend internal audits-Support engineering dept. In process validation -Training metrology inspectors and calibration technical -Provide technical support to any area needs.Goals done: √ Design and develop of Metrology Laboratory√ Create Gage R&R procedure √ Create metrology procedure√ Update dimensional equipment on incoming Inspection √ Reduce FAI Inspection time 75%√ Reduce Dimensional Inspection Cost @ 250K Dlls.

-Get calibration service quote and coordinate equipment shipments to manufacturers and/or external calibration laboratory.-Coordinate calibration service suppliers national and foreign-Coordinate calibration monthly plan compliance and give support to calibration technicians-Make the calibration monthly plan -Provide technical support for equipment installed in production. -Create or repair equipment measurement-Preparation and follow-up of abnormalities concerning measuring equipment-Equipment and/or tools Purchase-Calibrate measurement and test equipment against traceable standards, flowing approved procedures.

Activities by Area:Molding -Pre-production Approval. -First Article Approval.-QC Audit. -Customer Complaint. -Corrective Actions Request (CAR).-Customer Service.-Quality Meeting. -Synergy Group Leader. Incoming Inspection-Supplier Audit According Quality System.-AQL Audit.-Dimension test.-Supplier Corrective Actions Request (SCAR).Calibration-ID & Equipment Control.-Equipment Recall.-Calibration service quotes.-Sent and follow up calibration equipment.-Suggestion Equipment use According process.MRB-Provide RMA Numbers.-RMA’s Control.-Review & ID raw material. -Follow up QC problems. -Material Disposition.Goals done: -Develop an Inspector Quality Certification-Develop and Lead Synergy Program -Develop Incoming Inspection-Implement Supplier Development-Reduce Costumer complaint @60%-Implement the MRB meetings-Reduce MRB cost @85%-Implement a ID control

Activities:Control of documents of ISO system from cabinet departmentCalibration equipmentTorque SystemIncoming InspectionCampaigns od reductions defectsQC inspection trainingElaboration of defects reports