Ali Sajadi Email & Phone Number

Cologne, Nrw, De

Ph 17&18 - Assalouyeh-Bushehr-Iran

• Improvement of the Claus yield up to 96% (5% overdesign).• Level up the AGE performance by 20% by optimizing operational parameter.• Coordination to carry out preventive maintenance to reduce unpredictable stop by 25% to the previous period.

Middle East

• NGL Fractionation, Ethane Recovery and Treatment• Flare and Relief System Design• Sour water Stripping (SWS) and Sulphur recovery unit (SRU)• Tanks farms and custody measurement• Dehydration• Trouble Shooting in Oil and Gas industry• LPG fractionation and treatment• Heating network (Steam and Hot Oil)• Pump, compressor operation and performance• Air & N2 plant• Refrigeration

Ph 12 - Assalouyeh - Bushehr - Iran

• Full supervision of activities and technical calculation based on the requirement and time schedule of the project to recognize the roots of delays and reinforce them to prevent any delays.• Created and presented weekly and monthly reports to the executive in an accurate manner. Achievements:  I redesigned the organizational structure to make up for the project's three-month delay and make sure it was completed by the deadline utilizing my expertise and experience from past projects, as well as by identifying bottlenecks.

Iran- Siri Island- Ngl Recovery- Commissioning/Start-Up -Mission From Spgc

• After a thorough site visit, it was discovered that over 60 significant punch instances contributed to the five-yeardelay in the factory's opening.• Developing creative solutions based on engineering calculations and simulations to start up this unit at 40%capacity.• successfully cut the amount of propane purchased from onshore by 800 tons annually, saving $760,000 USD inoperating costs.

Phase 6,7&8 (Third Gas Refinery) -Assalouyeh- Iran (3300 Mmscfd Gas Refinery)

• Sequential checking of operational parameters to meet required product qualities. • Control of laboratory results and their compliance with operating conditions. • Supervise how staff perform their duties and evaluate them based on their performance. • Communicate and cooperation with site operators for obtain information about the final status of important equipment and record their conditions in the relevant log sheets. • Receive instructions and distribute them among people and plan to execute them as best as possible. • Write commissioning procedures like Water washing, Degreasing, Plastic shooting, OTP, and LTP and well acquainted with the Export/Refrigerant compressor preparing for the first start-up steps. • Performed overall assigned operations on time and as per the directions of the project manager. • Enhanced personal skills regarding advanced systems and various process units of a gas refinery and significant knowledge of construction, pre-commissioning, commissioning, start-up activities.

Master Of Science (Ms), Chemical Process Engineering Advance, Gpa=4.6

Bachelor'S Degree, Chemical Engineering Gas Production, Gpa=4.3