Specify, design, develop, build, test, qualify, document, and use experience with the following technologies for engineering, science, research, and production environments. Work over the years include electrical, electronics, some chemistry, audio, television, and mechanical systems. Optical work was the most enjoyable! This included solid state, flash-lamp pumped, gas, and diode laser bar assembly and testing. Laser systems and light sources at various wavelengths and powers for GaN material science were used in many of the material science experiments I was heavily involved with. Opto-mechanical and electro-mechanical systems were also utilized. Vacuum, pressure, and cryogenics for gas and liquids and the associated integration to control the environmental conditions for testing. Test fixtures with system integration options, test racks, and cable systems were always custom builds. Experience also includes the use of electron microscopy including SEM, dual beam FIB (sample prep for TEM), TEM, and E-Beam probers. Various thermal technologies from hot plates or baths to environmental test chambers. Failure analysis, reliability, HALT and HASS, and some chemistry has also been in the mix. Surface-mount and thru-hole electronic board assemblies, and some PCB layout (PCB123). Made custom power supplies, power conditioners, audio systems, power amplifiers, analog and some digital camera / sensor vision systems. Experience creating data acquisition and control systems primarily utilizing programming code with LabVIEW to automate many experiments. And, of course, Microsoft Office. Extensive experience with various standard and specialized laboratory test equipment for all of the above.