Anthony Morse Email & Phone Number

Wyandotte, Mi, Us

Oak Park, Mi, Us

Köln, Nordrhein-Westfalen, De

Worked on the assembly line, doing reworks on the vehicle chassis.Applied sealant to the body panels.

Livonia, Mi, Us

Removing catalyst an installing K-type TC's in them to test pre and post catalyst temperatures.Installing back pressure probes.Installed keil probes.Install fuel drains onto various makes an models, including but not limited to prototypes.Remote mount fuel vapor canisters.Full instrumentation builds.Build and install aux battery system.I am currently responsible for extending and modifying wiring on a wide variety of Ford/ Lincoln vehicles.Run a diagnostic system for DTC codes, then trouble shoot said codes.Flash various Control Modules. BCM, PCM, SSR.Assisting with the builds with prototype vehicles.

Newark, California, Us

Reworked various harnesses, throughout the vehicle. Extended wiring harnesses. Added in new circuits, pin or un-pinned various connectors. Ran an tested Ethernet cables, Deutsche connectors. read 2D prints, an schematics.

Clean and maintain part for the robotic system.Disassembly an reassembly of the valves and mixing chambers.Changing out the component totes.Changing the tips after each truck is sprayed.Cleaning the equipment for the spray booths.Keeping logs of any/all maintenance done during the shift.Changing booth filters, an robotic arm covers.

My job task's include, cleaning off an resetting tables for customers to enjoy there meals. restockingthe bar with various beverages, cut the fruit needed for drinks, also refill ice bins.

Kecskemét, Hu

I work with various vehicles diagnosing electrical issues, whether the issue is from assembly ormanufacturing.I dealt with coax wires, soldering, cutting and splicing of wires.Disassembly and reassembly of each vehicle.Running various testing equipment on each vehicle.

Charlotte, North Carolina, Us

My task's for my job included going over a general maintenance check list.i was to perform a routine oil change on various vehicles.general repairs if they were needed.

Livonia, Mi, Us

Assembly and disassembly of prototype vehicles for research and development. Areas of focus include, interior and exterior trim, power train, an electrical.I had to make sure all bolts or nuts were at appropriate torque spec.

I was removing various parts from various makes an models of automobiles.Once parts were removed from the vehicles, i had to input them into the inventory system, an put them on the correct inventory locations.