As Senior Mechanical Designer role in Mitel, directly report to Canadian.1, Work with PLM for Generation refresh, based on engineering perspective to providing manufacturable analysis to the team, part refresh, Update the 2D/3D on the PDM and share to team and 3rd party via Agile2, Maximize quarterly off AVL cost reduction numbers by driving the evaluation and approval of more cost-effective components3, Plastic, Die Casting, Metal sheet, rubber part verification and qualification. evaluate DFx, FAI report, drive the CM and supplier for inspection correlation and alignment, first line support for mechanical quality issue at the supplier.4, Perform root cause analysis and provide resolution of a mechanical problem in timely manner to avoid CM side production gaps, Main CMs of us are Flex, Celestica and Wistron.

1. NPI for casting parts customer have Bosch, Delphi, Magna, Tosok, parts include ECU housing, Steering heat sink, pump, transmission valve, E-Scooter, damper unit, leading team responsible for project start from awarding to mass production. New project introduces for Plastic parts customer have Magna, Danaher group (Hach, Leica, Kavo, Beckman), Cricut (Provo Craft), Dieblold Nixdorf, parts include car light system, Housewares industry, medical facility, dental tools and optical measure equipment units. cash drawer.2. Leaded design team give supporting to customer R&D for manufacturing feasibility analysis (DFM) and provide mold simulation analysis to customer, regular project meeting review with customer, to provide guide line to mold maker for tooling build up and make sure it fulfills target date. follow up tooling test, correction plan, parts assembly test, FA submission.3. Responsible toolroom daily operation, department KPI, discipline, security, factory requisite spence control and yearly cost saving.4. Production OEE improvement, parameters optimization, defect problem solving. Project Experience Name: HDD base plate yield improvement. Time: 2012.9-2012.12 Project title: LeaderProject: based on existing machine and manpower capacity, to increase casting output and reduce manpower pressure to fulfill 1.2m pieces/ month customer demand. Responsibility: 1, balance tooling ingate and runner system, twin cavities change to three cavities at 350 t machine. 2, upgrade the trimming cutter dismantlable to combine and locator of trimming punch to trimming part to size.3,change the CR 12 material to Delrin POM avoid surface dent during trimming but without bendingPerformance: increase 30% casting output, decrease dent defect rate from 5.5% to 0.5%