Brian Solomich Email & Phone Number

Menifee, California, United States

QA testing of inductors and transformers. Failure analysis of inductors and transformers.

Temecula, Ca

I was responsible for creating and maintaining destructive analysis processes for the Failure Analysis lab. Including mechanical decapulation, laser decapsulation, chemical decapsulation, backside preparation/planarization, fault isolation - liquid crystal, thermal emission, photo emission. Created operating procedures for Jet Etch, FALit laser decapsulation equipment, Allied high Tech multiprep system, Hypervision Photo Emision microscope, XIVA microscope, Keyence VHX-6000 optical microscope, Fein Focus Real Time X-Ray Imaging System and Hitachi S3000N Scanning Electron Microscope. Also responsible for safety training in the wet lab to include Fume hoods for acid and solvents. Responsible for ordering and stocking chemicals used in the FA lab. Also, perform destructive failure analysis on power MOSFET devies, ICs and Power modules and reporting findings to customers.

Greater San Diego Area

Responsible for aligning, testing, and repairing Line Narrowing and Stabilization optical modules for Excimer laser systems. Developed and revised test setups and procedures. Tracked and maintained Excimer Laser systems used for testing and aligning Line Narrowing and Stabilization optical modules.

Greater San Diego Area

Built, tested, troubleshot, and repaired prototypes for controlling MEMS based technology, including fiber optics communication lasers, optical detector modules and optical switch modules. Designed circuit layout for PCB boards. Responsible for ordering lab equipment and supplies from vendors.

Greater San Diego Area

I was a process-engineering technician in the final process/test area for 32, 27, 20, 17 and 15 inch Cathode Ray Tube manufacturing. I performed process improvements and failure analysis on these CRTs. I presented failure analysis data to upper management and other engineering groups on a weekly and daily basis. I did statistical analysis on test data for these CRTs. Reduced defect and rework costs by optimizing process conditions. Developed processing and testing for new products. Calibrated, tracked, and maintained electronic and process related equipment. Documented operating, testing, and processing procedures for ISO 9000 standards. Maintained test, diagnostic, and fabrication equipment used for process quality control. Responsible for ordering lab equipment and supplies from vendors.

Associate Of Arts (A.A.), Electrical, Electronics And Communications Engineering, 4.0

Associate Of Arts (A.A.), Liberal Arts And Sciences, General Studies And Humanities, 4.0