Dipal Shah (P.Eng) Email & Phone Number

Oakville, Ontario, Canada

Brampton

• Validating assembly process sequence and functional test results for Marine Filtration assemblies. Responsible for selection of measuring equipment to assure measurement uncertainty. Conduct daily meetings with the.
• Co-ordinate and participate in Material Review Board (MRB) meetings to facilitate disposition of non-confirming products using 8D. Chair non-conformance and corrective action meetings with the stake holders discussing.
• Supervising and validate customer warranty claims through technical analysis and evaluation of the product investigation, testing and establish report for the claims. Communicating the report with all the stake holders.
• Responsible for modification of calibration equipment for pressure gauges to make gauge calibration easy and cost effective when required. Monitor timely completion of monthly Calibration of mechanical, hydraulic and.
• Responsible to ensure that ASME certified pressure vessels built by supplier has gone through TSSA validation and meets to the requirements through verification of material reports, weld maps, welder’s qualification.
• Maintaining work performance records, inspection records and other related documents ensuring correctness of all documents on a project-by-project basis. Establish charts and report for daily,

Brampton, Ontario, Canada

• Four quality inspectors direct reported for training and any quality related issues
• Identified key product characteristics for new launch and deploy necessary controls to ensure product specifications met, ensure the APQP, PPAP (QMS) process followed and fully conversant with all aspects
• Programed and operating Co-ordinate Measuring Machine (CMM)
• Conducted various tests and quality checks on finished products. Ensure that all products have been tested and fall within standards, measured to specifications and within tolerances, readability of labels, etc
• Monitored performance by gathering relevant data and producing statistical reports
• Visited various customer sites and resolved on site issues, also communicated effectively with various customers like Toyota, Honda and GM.

Toronto, Canada Area

 Conducted visual inspection for the Toyota launching parts Operated and calibrated Co-ordinate Measuring Machine (CMM) Responsible for the tension test for Honda door joints and assisted in part capability studies & gauge R & R’s Recorded & charted all required SPC inspection as per frequency on control plan, noted NCRs and following 5s process..

Bachelor Of Technology (B.Tech.), Manufacturing Engineering

Diploma, Mechanical Engineering