DWAYNE DUPRE156 RAY LANE CHURCH POINT, LA 70525CELL# 337-351-7332jdcdups@yahoo.comI am seeking a challenging position where I can utilize a wide range of skills, knowledge and experience as a welder/fabricator/fitter and as a utility inspector in the oil and gas industry.Qualification SummaryThirty plus years of experience reading blue prints, fabrication and piping compressor stations, pump stations, gas distribution systems above and below ground with taking and reading elevation. Way over 1000 miles of pipelines and tie-ends including integrity digs. High professional standards with job focus on dependability with extensive safety training and ability to obtain project requirements and effectively deliver appropriate solution.Experience SummaryBaywater 7/2021 to 7/2022 Welder/Fabricator/Fitter in LAFabrication from blueprints 2” to 12” flow-lines including installation for plant upgrade, 36” pipeline and integrity digs.Sunland Construction 9/2019 to 5/2021 Welder/Fabricator/Fitter in LA, FL Fabrication from blueprints all piping size from 2” to 24” for new compressor station facility with installation of piping, tie-ends.Pilgrim Construction 11/2018 to 7/2019 Welder/Fabricator/Fitter in Tx From blueprints fabrication of new addition to existing Plains plant which included flow lines, manifolds, platforms and braces.Stallion Oilfield Construction 5/2018 to 10/2018 Welder/Fab/Fitter in LA As a independent contractor refurbish existing well sites pulling measurements, rebuilding manifold, flowlines, platforms and braces. Low Construction 5/2017 to 3/2018 Welder/Fabricator/Fitter in MS, AL,SC Integrity digs of 30”, 36”, 42” pipe and valves. New pump station fabrication and installation.Boan Contracting 11//2008 to 2/2017 Welder/Fab/Fitter LA, TX, MS, AL Pipeline, compressor station, pump stations. Fabrication of many projects.Production Hookups 8/1999 to 9/2008 Welder/Fabrication/Fitter offshore Offshore platform construction and fabrication of all size pipe and completion of site installation with supervisor roll.EducationWelding- T.H. Harris school30 plus years experience of on the job training Reading blueprints and ISO'sTaking and reading elevation Welding and fabrication with 2” through 42”