Russel Ibrahim Email & Phone Number

Power and Actuation Systems (PAS)

Control Actuations System (CAS)

Avenel, New Jersey, United States

Work with power converter systems for various Aerospace applications

Eatontown NJ

• Design and implement Power Inverted Unit (PIU) used in various governmental and commercial aerospace systems ranging from 30 to 150KVA capabilities.
• Troubleshoot complicated system down to component level by utilizing keen observation and critical thinking skills with knowledge of electronics. Additionally, work with vendor on implementing corrective action after.
• Design, test, troubleshoot and validate various system faults condition, including but not limited to over/under voltage, over current, feeder fault, ground fault, over temperature and open point of regulation.
• Design custom test systems using LabVIEW and Arduino to validate functionality of circuit boards.
• Implement test systems in accordance with DO-160 Protocol.
• Maintain current knowledge of industry standards for Variable Speed Constant Frequency (VSCF) and brush-less generators technology.

Ewing, NJ

• Participated in design and development of medical electronic equipment such as ECG monitoring systems.
• Diagnosed root cause of electrical or mechanical malfunction of failure of operational equipment, and perform preventative and corrective maintenance using principles and theories of science, engineering, and.
• Built, customized and troubleshooted electrical designs including microprocessor based hardware
• Worked with schematics and PCB design and handle mechanical part of design
• Produced charts/documentation on failures; trained QA/Manufacturing on defects/resolution
• Planed, directed, and recorded periodic electrical testing, and recommended or initiated modifications or replacements of equipment that fails to meet acceptable operating standards.

• Developed new LCD products from integrating various touch screen, display, single board computer and controller board from various manufactures.
• Prepared quotes and technical proposal based on specific customer requirements.
• Maintained expert level of understand of current LCD, touch screen and computer board products in order to assist customers in choosing an application-specified solution. Technical knowledge included LCD technology.
• Organized multiple jobs criteria and keep track of available inventory using Epicor Software.
• Travelled to customer site to perform key project support.

• Designed wall partition interface controller that intelligently route electronic motors to wall switch based on dry contact command.
• Designed included Schematic using Orcad, Firmware using Arduino and PCB layout using PCB123Create schematic for design using Orcad.
• Assisted in developing a 0-10VDC network communication control for motor.
• Troubleshooted motors and controllers product returned from customers.
• Tested motor commands using an rs232 network.
• Installed software/firmware that uses Echelon LonWorks before it gets send into production.