• Manages the overall production operation-Conduct and supervise quality control inspection for incoming and outgoing shipment.-Perform/supervises Geometry, Dimensional and Tolerancing for first article inspection of new parts and products.-Supplier quality monitoring on shipments received. Issue and monitor Corrective/Preventive Action Request for parts rejected during quality control inspection.-Monitoring of gauges and equipments for calibration.-Supervises testing of electronics for instrument transmitters and indicators prior to assembly.-Oversee the production schedule to make sure delivery to customer is met.-Issue work orders to production team and supervises the assembly line.-Issue PO to suppliers and coordinate shipment to ensure without delay.-Shipment documentation and coordination for outgoing orders.-Maintain updated record on inventory count in the store/warehouse.-PT100 Temperature sensor assembly and Temperature sensor calibration with Ametek Jofra 600 calibrator.• Management Representative to Certification Body-Factory representative for ISO 9001:2015, ATEX, IECEx, FM and CSA Quality Management Systems-Prepare documentations and handles quality management systems certifications and surveillance audit for ISO 9001:2015, ATEX, IECEX, FM and CSA certification body.

• Developed an Intelligent Power Distribution Module for NISSAN programs-Performed Worst Case Analysis for digital and analog inputs, high and low side drivers-Develop hardware schematic design for Nissan IPDM-Provided Design Failure Mode and Effect Analysis (DFMEA) on functionality critical to safety-Conducted a hardware validation testing and reports for the designs-Electronics Benchmarking (Schematics tracing and BOM generation)-Create schematic and generate BOM for RFQ.-Engineering evaluation using Reliability Prediction, Fault Tree and Sneak Path Analysis-Failure analysis investigation and Plant support for warranty issue investigation-Notice of Modification documentation for hardware design change.-Develop test specification for plant End of Line testing.

Provide 2D electrical drawing layout for automotive wire harness using EDGS software.-Provide 2D electrical drawing layout for automotive wire harness using CapH software.-Provide 2D drawing layout for automotive components using AutoCAD software.-Provide 2D electrical drawing layout check against 3D drawing layout using IDEAS 3D software.-Generate Bill of Materials and labor cost and time for each component.-Develop product specifications and procedures.-Create Engineering Change Request for wire harness updates