Andrew Frey Email & Phone Number

Denver, CO, US

• Pipeline Design/Integrity Engineer – May 2018 – CurrentEngineering support to operations, design of pipeline facilities. Area of responsibility - 254-mile, 1 BCFD gas pipeline. Return on investment recommendations to.
• Perform pipeline simulation and system optimization (Synergi Gas, STONER SPS). Optimized compressor usage, percent duty levels, and performed meter accounting for lost and unaccounted-for (LAUF) gas studies.
• Design engineer and engineering construction support for 7.8 mile 36” 223 MMCFD expansion project
• Detail design of pipeline facilities: compressor stations, interconnects, filters, meter & regulation stations, pig launchers/receivers, over pressure protection, flow reversals.
• Engineering of design deliverables – piping & instrumentation diagrams, process flow diagrams, piping plans, material specs, MAOP verification studies, site layouts, material engineering procurement engineering and.
• Horizontal directional drilling design - drill and pullback design and load calculations.

San Diego, California, US

• New engineering consulting group in Atlanta to service regional natural gas distribution companies.
• Designed and managed high-pressure gas distribution line relocation, retrofit, and remediation projects.
• Conducted pipeline integrity assessments using smart pigging ILI data, performed MAOP verification using RSF calculations. Creation and management of ILI smart pig mapping database.
• Developed hydrostatic test plans, flow interruption and line switching plans for hot taps.
• Configured software leak detection system for liquid pipeline projects.
• Field engineering - provided construction support, on-site inspection.

• Developed and reviewed PFDs for a proposal to revamp a gas sweetening plant in Bolivia.
• Reviewed existing equipment data sheets to verify heat and material balances process conditions.
• Cost estimation for project engineering services of separate project tasks.
• Performed pipe velocity calculations to validate process conditions within maximum allowable velocities.
• Reviewed existing equipment data sheets to verify material of construction suitability for proposed amine service.
• Process simulation using software – Gas collection, pipeline, MDEA sweetening, glycol dehydration, demethanizer columns, sulfur recovery units, & separator sizing projects.

Reston, Virginia, US

• Long term assignment in-country; multinational expat engineering group supporting newly acquired contracts.
• Trans Anatolian Natural Gas Pipeline (TANAP) 1750 km, 1.6 BCFD 56" Natural Gas Pipeline – FEED.
• Performed pipeline route verification, bend design, and determined main line valve site locations.
• Performed high consequence area risk assessments to determine wall thicknesses.
• Developed first phase construction contract bidding proposals.
• Developed crossing list and prepared pipeline route constructability reports using GIS data.

• Midstream Facilities Engineering group providing discipline engineering as well as project engineering services.
• Enbridge Line 59 Cushing, OK pipeline terminal 1 MMB/D. Mechanical detailed engineering design for tank terminal piping, pumps, and manifolds.
• Performed terminal tank system hydraulic analysis, stress analysis using Caesar II and PIPESTRESS.
• Oversaw drawing control, revision management, spec CADWorx database changes, issued drawings to clients.
• Enbridge Line 61 Mainline Expansion project 462 miles of existing 42” crude pipeline from.4 MMB/D to 1.2 MMB/D. Mechanical FEED and detailed engineering design for 12 pump stations (greenfield and co-located)
• FEED- Project engineer responsible for coordination of all disciplines. Performed pipeline hydraulic analysis to determine targeted pipeline capacities and flow rates, Pipeline route verification.

The Woodlands, TX, US

• Managed plant safety guidelines and conducted investigations of plant safety incident reports.
• Managed maintenance program for small process and vessel pump equipment
• Coordinated plant operations work process optimization and notably improved liquid material waste
• Created MSDS electronic database for older inventories
• Design of supports and tie ins for new kettle equipment
• Procurement for small process equipment as well as technical evaluations for bids

Bachelors, Mechanical Engineering

High School Diploma, General Studies