• Acts as the primary contact engineer overseeing the Sulfur Recovery Unit (SRU), Amine Treating Unit (ATU), Sour Water Stripper (SWS), Tail Gas Treating Unit (TGT), Mixed Xylene Splitter (MXU), and the Propylene Recovery Unit (PRU) ensuring smooth operations and adherence to safety protocols.• Acts as an alternate Engineer for the Continuous Catalyst Regeneration Unit (CCRU) and BT Extraction Unit (BTX) to assume responsibilities in the absence of main contact engineers, ensuring continuous and efficient unit operations.• Facilitated shutdown and startup of key refinery units during the May 2023 Turnaround. Optimized start-up and shutdown schedules through updated Gantt charts, resulting in earlier on-spec product delivery.• Conducted initial and final inspections of heat exchangers, drums, and towers during turnarounds.Identified abnormalities in plant equipment, providing maintenance recommendations for enhanced operational efficiency.• Troubleshooted multiple process upsets, delivering recommendations to maintain stable operations.• Generated unit monitoring reports for management, offering insights and suggestions for continuous improvement.• Performed mass balance calculations for Planning and Statistics, providing up-to-date Petrochem product yield data.• Created guidelines for first-time activities, unit optimization, and irregular plant activities, emphasizing safety, equipment integrity, and profit maximization.• Utilized process simulation software for troubleshooting process upsets, resizing valves, lines, and re-ranging flowmeters.• Employed Excel and process historian databases for equipment operation evaluation and viability assessment.• Conducted regular Subject Matter Expert (SME) lectures for new hires, facilitating a deeper understanding of processes and solidifying knowledge on assigned units.

• Undergone two months of training under the technical training department of JGSOC and got to know basics of troubleshooting plant equipment, plant safety and the general knowledge in the petrochemicals industry by being exposed to plant processes and operations.• Played an active role in plant construction, pre-commissioning of a new Dual Loop Slurry polyethylene reactor from line tracing, hydrotesting and piping cleaning ensuring all process and utility lines are ready for commissioning• Part of a commissioning team of the said Dual Loop Slurry Polyethylene Plant. Ensuring safety and smooth operations by abiding by the plant's work permit system, reading operating parameters on the field, and logging them in to compare with the DCS parameters, making fine adjustments using manual valves and coordinating these adjustments to the panel operator.• Performed low pressure and high-pressure leak checking of plant piping and vessels, passing tests of manual and control valves and function testing of plant BPCS and SIS ensuring that the controls are working at the field by communicating to the panel operator the status of equipment and valves.• Performed routine monitoring and operations of the equipment in the assigned area, data logging and analysis and generated reports of abnormalities and incidents. Carried out sampling as required by the laboratory tests.• Performed minor maintenance works and troubleshooting and coordinated with the panel operator. Identified and reported equipment or system that requires maintenance. Monitored the progress of maintenance work in the assigned area.• Participated in safety walkthrough and safety audits in the assigned area. Ensure the good housekeeping of the plant.• Written daily reports on the activities of the plant to handover to incoming shift for smooth operation and to backtrack adjustment made in the field

• Conducted daily safety walk-by inspections in designated areas, proactively identifying potential plant hazards.• Played a key role in maintaining plant housekeeping standards, ensuring a safe and organized work environment.• Gained hands-on experience in product cement testing and raw materials testing within the QA/QC lab.• Executed testing procedures to uphold quality standards and contribute to product quality assurance.• Sorted and organized finish mill equipment manuals, ensuring accessibility and ease of reference.• Updated documents related to Hazard and Operability (HAZOP) and Hazard Identification, Risk Assessment, and Control (HIRAC) for the finish mill, ensuring compliance with safety protocols.