Software Development for Body Control Module and Bootloader based on Power PC Architecture.

Extended Body Control Module (XMC):Developed Boot loader for Extended Body Control Module (XMC) based onFreescale Power PC MPC574x series Controller. Hands On Experience on Vector CANGeny and Da Vinci Configurator for CAN and Memory stacks.NANOSAR:Developed Nanosar (Scaled Down version of Autosar) Architecture for Medium and Low End Controllers for Drive Electronics Platform portfolio. This architecture has the advantage of Low memory footprint suitable for small controller and still having Autosar flavor.

Developed SW Requirements, Design Code for Micro controller based BLDC Motor control Solution.

Intelligent Data Acquisition & Recording Unit:Description:This project is a GPS-GPRS based Intelligent Data Acquisition and Recording Unit. The system has been presently deployed in Vehicle Tracking & Accident Analysis Unit. It gets real time GPS location data, Speed Information & fuel quantity through respective Sensors, log in information through RFID, vehicle status through Human Machine Interface and processes them for Sending to the central server over GSM for tracking and statistical analysis.Responsibilities:• Responsible for writing low level driver & application for modules.• Involved in system design and development.• Writing Driver using C• Unit Testing &MaintenanceMOBILE DATA TERMINAL (MDT):Description:As a part of Complete Fleet Management Solution A mobile data terminal (MDT) device has been used in public transport vehicles, taxicabs, courier vehicles, service trucks, commercial trucking fleets, to communicate with a central dispatch office.Responsibilities:Responsible for writing Hardware Abstraction Layer & Low Level Driver for sensor Modules, their testing & maintenance.ON BOARD DIAGNOSTIC (OBD-II) DATA LOGGER:Description:It is an On Board Diagnostic –II (OBD ii) protocol based data logger system designed around NXP’s ARM CortexM3 Controller. It communicates to vehicle’s OBD port on any of the CAN, RS232 or Keyword protocol and queries for Engine Control Unit & Transmission Control Unit and other data. The above data is acquired and sent over the GSM to central Server unit for in time information of vehicle health and thus cutting down extra cost incurred on catastrophic failure and maintenance.Responsibilities:In this project responsible for writing firmware driver of RS232-KWP-CAN protocol converter System on Chip (SOC), Message parsing and interfacing with Host Controller.

Company: Powergrid, BhagalpurRole: Asst. EngineerTechnologies: Embedded CTool: Code Composer Studio. Role: DeveloperDuration: Feb 2010 to Aug 2011 Team: 4Description:Low cost Electronic Energy Meter with temper detection based on Analog Device’s system-on-chip (SOC) and NXP’s Cortex-M3 core• Data Acquisition from input and signal conditioning.• Processing of the acquired data using DSP core.• Sending above data/ tempering information to the storage device. Responsibilities:• Involved in system design and development.• Involve in Data Acquisition and Digital Signal Processing using C.• Unit Testing• MaintenanceConstruction of Sub Transmission Substation:Worked as Assistant Engineer in Power project.Completed Installation of SCADA.