Jovan Vedrene Email & Phone Number

United States

As an electronics technician my role is to test underwater cables to make sure that they’re functioning properly for electricity to flow from one point to the next.1) Reading cable designs on drawings.2) Testing for a high voltage cable tester for the correct voltage and resistance.3) Writing a test program and a set of instructions for specific cables.4) Soldering wires that will made up cables.5) Assembly testing cable pendants that aid in measuring voltage and resistance of cables.

San Diego, California, United States

1. Establish a stable power supply.2. Ground the system for stability.3. Connect power supply to input circuits.4. Link input circuits for interconnecting components.5. Extend to output circuits for complete circuitry.* Electronic design & stimulation* Soldering & Building On Breadboard* Assembling & Wiring* Prototyping & Programming* Testing & Operate Electronics* Maintenance & Identifying Common Faults* Troubleshooting & Repair* Upgrading electronics* Installing electronics equipment

United States

Working with electromechanical equipment such as painting, cutting and lifting equipment by--Testing and operating electromechanical equipment-Performing preventative maintenance-Identifying potential faults-Troubleshooting & repairing faulty equipment

United States

Assembling & wiring electrical components that go onto freedom cases that contain merchandise goods. When customers put their phone number the camera on the freedom case recognizes their face & allows them to open up the case to take merchandised goods.

San Diego, California, United States

I built electrical panels for gas turbines & panel boxes by a step by step process accordingly after I clocked into a specific job, received working instructions & layouts from the manufacturing engineer.1) Grab the panel according to the engineer’s layout.2) Measure & cut rails & pan-ducts.3) Drill a frame ground into the panel.4) Drill holes onto the eyes of each rail that I cut individually.5) Assemble panel mounted components.6) Assemble stand off onto the panel.7) Drill the rails onto the stand offs & drill ground wires onto the rails.8) Assemble rail mounted components.9) Put blue labels onto the panels according to where the components were assembled.10) Mounted the pan-ducts into the panels & clean any remaining residue.Wire the panels starting with:1) Ground wires, jumpers & clips2) Wiring relays & timers starting from smallest gauge wires to largest gauge wires.3) Wiring other components from smallest to largest gauge wires.4) Connecting cables from smallest gauge to largest gauge if the wire list call list calls for it.

San Diego, California, United States

Assembled and wired medical equipment. This equipment acted as a fridge/freezer for vaccines.

Electronics Technician, Industrial Electronics Technology/Technician, 3.8

Activities and Societies: No specific social activities. My skills, hobbies and interest range from drawing manga, to dancing, learning.

Electronics Technician Certification, Industrial Electronics Technology/Technician, A

* Perform continuity test from power supply & ground-output circuits & ports. * Measure the voltage & current of the power supply. *.

High School Diploma, General Studies, A-

Activities and Societies: Drawing manga, Bboying, House Dancing.Throughout high school I not only graduated in 3 years, but ended high.