Keaton Mccormick Email & Phone Number

Montgomery, TX, US

College Station, Texas, United States

• Provided support on protocol creation, execution, and documentation.
• Performed pre-calibrations, pre-verifications, and post-calibrations on Ellab thermocouples, loggers, and temperature standards.
• Wrote various lifecycle documentation: URS, SIA, risk assessment, etc. for cell culture process equipment.
• Read LOTO (Lock Out Tag Out) plans and confirmed the correct positions of a system were LOTO’d and a run could safely be setup with thermocouples, loggers, etc.
• After the Validation team sets up a Bioreactor/Centrifuge with probes, supported the CVQ team with a pressure test and identified and fixed any positions where a leak was present.
• Supported SIP qualification on USP Bioreactors, Media Hold Bioreactors, Media Filtration Lines, Centrifuges.

Lengnau, Berne, Switzerland

-Perform risk-based commissioning, qualification and validation service for pharmaceutical and biopharmaceutical clients on Process Equipment, SIP to demonstrate that the equipment is fit for its intended use.-Review, analyze, interpret, and summarize system and process performance data of executed activities for report and presentation to.

College Station-Bryan Area

o Environment Chamber Validation: Freezers, Refrigerators, Warehouses, Cold Rooms, Chart Recorders, Liquid Nitrogen Storage Freezers, Stability Chambers, Bioreactors, Single Use Chromatography Skid, Sartorius CS1000 Single-Use TFF, Sartorius CM150 Single-Use TFF, Palletank Mixers, Biowelders, Biosealers, Sartocheck 5 Plus Filter Integrity Tester, Palletank.

• Provided support in tracking the progress of the Robotic Arm stations that were installed by the third-party contractor, Cushman and Wakefield and relayed the updates to the Amazon Robotics team.
• Performed troubleshooting on the robotic drives and identified and fixed any drives that were working improperly.
• Coordinated with the Cushman and Wakefield team daily to provide goals, timelines, and solutions.

Houston, Texas, United States

• Provided design engineering support using Solidworks to optimize product lines and come up with solutions that meet the clients’ needs.
• Provided training to assembly personnel on equipment that was new to Tally.
• Analyzed inventory at the site and recorded all equipment with updated quantities to present to management for the yearly audit.

Houston, Texas, United States

Houston, Texas Area

Conroe, TX

Bachelor Of Science (B.S.), Mechanical Engineering

Activities and Societies: Men’s Tennis Team

Associate Of Science - As, Engineering