Keith Denney Email & Phone Number

Lehi, UT, US

United States

• Managed employees to Implement, Support an electronic Work Order Routing and Quality Software.
• Process/System Owner to develop and improve an in-house eDHR, DMR Software to meet regulations and business requirements.
• Global Rollout, Training and Support for several US states, and internationally for Mexico, Ireland, Netherlands, Singapore.
• Managed material change projects from material testing to implementation.
• Designed Injection Molded Parts and implemented them for production.
• Sustaining Engineer for Medical Device production lines. Updated documentation and work with the production team.

Draper, Utah

• Validation and documentation process with performing and writing SOP’s, IQ’s, OQ’s, PQ’s PPQ’s.
• Addressing operator complaints and suggestions for improvements along a manufacturing line.
• Knowledge of FDA guidance reports and FDA 21 CFR 820
• Investigated root-cause failures for CAPA and Non-Conformances (NCR) followed by the implementation of the Appropriate Correction, Corrective and Preventive Actions
• Implemented changes and updates through the in process change control for procedures and Engineering Change Notifications (ECNs)
• Evaluated test data using statistical methods (Minitab) to pass and release lots. Further used the data to investigate the root cause of the failure

Kennewick, Washington

• Cut the cost by almost $700 of their current solar sterling engine
• Modeled Solar engine vibrations with FEA (ANSYS) Software to verify improvements
• Helped build a test engine to simulate specific vibration modes
• Worked with 14 other interns and engineers

Moscow, Idaho

• Prepared the lab for data acquisition, low-pass and data analysis labs
• Assisted 16 students per lab to complete labs and understand their purpose
• Graded post lab reports and be tutored an average of 40 students

Rexburg, Idaho

• Designed poultry enclosures using product development techniques
• Built prototypes to test for reliability and longevity
• Prepared documentation that was implemented in Paraguay a few weeks later

Morgan Hills, California

• Designed and tested a cardiac device for early detection of Peripheral Artery Disease
• Developed list of electro-mechanical components to measure signs of the disease
• Collaborated with 4 engineers, 2 machinist and out-of house manufactures to develop working prototypes
• Used SOLIDWORKS for an unusual R&D project; automated picture frame assembly

Bachelors Of Science, Mechanical Engineering

• Designed a robot with four wheel drive and independent suspension • Developed a mathematical of model to see the benefits of evaporative.

Masters, Mechanical Engineering

• Researched tracking points on the finger and the thumb in two and three dimensions • Assisted in designing a prototype to rehabilitate.