• Daily KPI monitoring of 4G sites by analyzing stats using NetAct and to performance improvement, parameter consistency checking, fault finding and troubleshooting of the assigned areas.• Improving CSSR, DCR, handover SR, resolving CA/ CSFB / Flash CSFB & VoLTE / SRVCC issues and providing recommendations to Telenor.• Identifying the cause of degradation in accessibility & retainability KPIs and giving recommendations to improve.• Engaged with stakeholders on regular basis to… Show more • Daily KPI monitoring of 4G sites by analyzing stats using NetAct and to performance improvement, parameter consistency checking, fault finding and troubleshooting of the assigned areas.• Improving CSSR, DCR, handover SR, resolving CA/ CSFB / Flash CSFB & VoLTE / SRVCC issues and providing recommendations to Telenor.• Identifying the cause of degradation in accessibility & retainability KPIs and giving recommendations to improve.• Engaged with stakeholders on regular basis to address their concerns and any changes so that it can be handled timely. By doing so product/service quality-related issues can be avoided. • Developed interactive Power BI dashboards and reports to analyze network performance KPIs, coverage, and capacity trends, aiding in data-driven optimization strategies. Show less

• Daily monitoring of New York & Boston5G ATP sites (n66, n71, n70) and resolution of on ground issues (Sector Swap, Low Throughput issues, mobility issues). • Monitoring of major KPI’s by analyzing stats using E// ITK and perform analyses for worst cells.• Cluster analysis (Poor RSRP, SINR, CQI, HO failure) via XCAP layer 3 messages after drive test (XCAL). • Parametric using BO and physical changes recommendation proposed to customer after cluster analysis for problematic… Show more • Daily monitoring of New York & Boston5G ATP sites (n66, n71, n70) and resolution of on ground issues (Sector Swap, Low Throughput issues, mobility issues). • Monitoring of major KPI’s by analyzing stats using E// ITK and perform analyses for worst cells.• Cluster analysis (Poor RSRP, SINR, CQI, HO failure) via XCAP layer 3 messages after drive test (XCAL). • Parametric using BO and physical changes recommendation proposed to customer after cluster analysis for problematic sites/coverage hole patches. Show less

• RF nominal planning/optimization of USF300+ RO sites (GSM/UMTS/LTE) sites on 9955 Nokia RNP tool for Dadu, Thatta, Jamshoro, Hyderabad, Chaghi, Karachi-Quetta highway, Tharparkar, Sanghar, Muzaffargarh, Jhang in South & Central region of Pakistan. • Daily coordination with teams/customer (TP/Nokia) and stakeholders (SA, RF, PMO, Txn) for smooth delivery of project and scope management.• Responsible for pre-launch optimization and Acceptance of Roll out sites from… Show more • RF nominal planning/optimization of USF300+ RO sites (GSM/UMTS/LTE) sites on 9955 Nokia RNP tool for Dadu, Thatta, Jamshoro, Hyderabad, Chaghi, Karachi-Quetta highway, Tharparkar, Sanghar, Muzaffargarh, Jhang in South & Central region of Pakistan. • Daily coordination with teams/customer (TP/Nokia) and stakeholders (SA, RF, PMO, Txn) for smooth delivery of project and scope management.• Responsible for pre-launch optimization and Acceptance of Roll out sites from customer.• Performed soft/hard parametric changes via ZTE (EMS, NET Numen) for optimization on highly utilized & traffic imbalance sites. • Customer complaint handling & troubleshooting within the given SLA to improve customer experience. • Quality audit is performed regularly to avoid any scope creep/gold plating compared to approved baselines and compliance requirements can be met as per company policies.• Engaged with stakeholders on regular basis to address their concerns and any changes so that it can be handled timely. By doing so product/service quality-related issues can be avoided. • TSSR evaluation of planned sites to ensure good coverage on target hotspots. • Responsible for Site On air and Layer addition (L850, L1800) upgrade activities. Show less

• Responsible for RRU swap and was part of launching more than 1200+ U900 sites in Karachi and Quetta MBB project. • Performed pre-optimization to meet the required KPI’s target for commercial launch. • Strategic planning of scrambling code and Neighbor declaration for better performance. • Investigation and resolution for RRC and RAB failures, Pilot Pollution, BAD ECNO and RSCP, Soft, Softer and IRAT Handovers failures. • Monitoring Quality-of-Service indicators like RRC Setup… Show more • Responsible for RRU swap and was part of launching more than 1200+ U900 sites in Karachi and Quetta MBB project. • Performed pre-optimization to meet the required KPI’s target for commercial launch. • Strategic planning of scrambling code and Neighbor declaration for better performance. • Investigation and resolution for RRC and RAB failures, Pilot Pollution, BAD ECNO and RSCP, Soft, Softer and IRAT Handovers failures. • Monitoring Quality-of-Service indicators like RRC Setup success rate, RAB Setup success rate, CDR (PS & CS) taking necessary actions for troubleshooting. • Hard optimization: adjustment of azimuths tilts for dominance. Identifying and eliminating Pilot pollution, Resolving sector swap • Involved in RTWP activity to reduce uplink interference on 3G Rollout site. Show less

• Daily 3G/4G KPI monitoring, performance improvement recommendations, parameter consistency checking, fault finding and troubleshooting using E// ITK & BO.• Improving handover SR, analyzing & tuning of ANR algorithm and providing recommendations to improve.• Network capacity monitoring & providing recommendations for traffic balancing between carriers (L1800 & L2600) by tuning HO parameters.• Monitoring and Troubleshooting 3G Performance KPI such as (CS/PS Call Drop Rate, CS/PS… Show more • Daily 3G/4G KPI monitoring, performance improvement recommendations, parameter consistency checking, fault finding and troubleshooting using E// ITK & BO.• Improving handover SR, analyzing & tuning of ANR algorithm and providing recommendations to improve.• Network capacity monitoring & providing recommendations for traffic balancing between carriers (L1800 & L2600) by tuning HO parameters.• Monitoring and Troubleshooting 3G Performance KPI such as (CS/PS Call Drop Rate, CS/PS Call Setup Success Rate, RRC/RAB Success Rate, Soft Handover Ratio, CS/PS IRAT Handover Success Ratio, HSDPA/HSUPA Throughput. • Responsible to take all necessary measures to reduce DL Power, UL Power, UL CE, DL CE and Code Congestion in network for CS/PS. • CAC tuning for congested sites. • Coverage analysis and recommendation to improve cluster RSCP and Ec/No. • Performed neighbor Planning/audit based on strategy. Show less

• Daily monitoring of 3G KPI (RNC & Cluster level). • Analysis of worst cell w.r.t to RTWP, CS/PS RAB congestion & drop. • Roll-Out/Acceptance/Optimization and Services Optimization experience. • RSCP, interference and coverage issues identification and resolution. • Neighbor/Parameter audit & Frequency tuning for new sites.

• Worked in ZONG as an RF Engineer in RAN Ericsson using BO. • Ericsson Network Performance analysis, Management Reporting & Optimization of Network Performance improvement through analysis of KPIs (CSSR, CDR, TCH Blocking / Drops, SDCCH Blocking / Drops, HOSR, Location update) on city, BSC and cell level, ensuring that contractual KPIs are met. • Monitoring and troubleshooting cells, in accordance to the contractual QOS (Quality of service), such as improving DCR (Drop Call Rate), TCH… Show more • Worked in ZONG as an RF Engineer in RAN Ericsson using BO. • Ericsson Network Performance analysis, Management Reporting & Optimization of Network Performance improvement through analysis of KPIs (CSSR, CDR, TCH Blocking / Drops, SDCCH Blocking / Drops, HOSR, Location update) on city, BSC and cell level, ensuring that contractual KPIs are met. • Monitoring and troubleshooting cells, in accordance to the contractual QOS (Quality of service), such as improving DCR (Drop Call Rate), TCH Blocking, HSR (Handover Success Rate). • Detailed analysis of drive test logs of a city or cluster and propose changes including change of BCCH, Azimuth & or Tilts modification, Identification of spillages, Faulty Hardware escalation etc. Show less

work as a internee in transmission department(OMC).Monitoring of optical and electrical tramsmission