- Perform investment grade energy audits of commercial buildings in and around New York City for whole buildings and tenants. - Advise clients in compliance with New York City LL97 (limiting greenhouse gas emissions) - Conduct hospital focused energy audits to target critical and lucrative energy savings retrofits.

- Measurement and verification of energy savings for energy efficiency rebates. - Calculate/quantify proposed project energy savings. - Propose energy efficiency solutions, from lighting to manufacturing.

• Responsible for day to day plant operations, column operation and maintenance, fermenter clean in place, boiler water chemical maintenance, inventory updating. • Administrated Tobacco & Trade Bureau company to company bond transfers• Developed and maintained standard operating procedures for gas chromatograph (GC) calibration, GC method preparation, fermenter and continuous column in place cleaning, boiler maintenance, and bio-based n-butyl-acetate production. • Designed and implemented electro-mechanical fluid level controller.• Established and implemented flammable transfer areas to keep facility within national fire code. • Performed insulation energy savings analysis, and economic feasibility study of hot water storage tanks.

• Instructed and guided classes of 44 through engineering design projects. • Prepared short lectures. • Introduced students to grammar and logic of technical writing. • Evaluated and graded project reports, resumes, memos and presentations. • Prepared handouts. • Coordinated team design exercises. • Initiated discussions.

• Investigated viability of sputtering for fabricating intermetallic compounds of Al-Cu.• Designed, drafted using Solid Works, and machined fixtures for polyamide film substrates and masks to mount on sputtering chamber turntable.• Conducted design of experiments relating sputtering parameters, time, power, and sputter radius to deposited film thickness.• Procured and set up data acquisition unit to monitor and record sputter guns.

for the Scientific and Technological Research Council of Turkey (TÜBİTAK) performed at Özyegin University, Istanbul in collaboration with Middle East Technical University, AnkaraProject: To measure radiative heat transfer between plane parallel plates with nano-scale spacing (to quantify the near-field effect)• Designed and built measurement setup and laboratory from ground up.• Designed and worked with machinists to fabricate assembly fixtures and test fixtures • Worked with team from three universities, including nano-fabrication group at Middle East Technical University to design nano-structured samples.• Measured near-field radiative heat transfer in samples.• Quantified measurement uncertainty.• Performed thermal resistance analysis of system for heat spreader design using Solid Works and Comsol.

for the Scientific and Technological Research Council of Turkey (TÜBİTAK) performed in the Physics Dept. at Koç University, Istanbul in collaboration with the National Council of Research, Institute for Microelectronics and Microsystems in Rome, ItalyProject: To fabricate and measure proof of concept tunable optical micro-resonator for telecommunication or optical switch applications• Repaired and calibrated laboratory optical monochromator.• Lead undergraduate researchers in LCD monitor reverse engineering and salvaging.

• Instructed problem-solving sessions.• Maintained regularly scheduled office hours.• Administered exams and quizzes.• Graded quizzes.

• Guided and directed students in conducting experiments and writing reports. • Prepared introductory lectures.• Prepared quizzes.• Graded reports.• Prepared report grading rubric handouts.

• Worked with Takata and Kettering Advisors with fabricators and test technicians to develop a repeatable test procedure for evaluating the effect of repeated testing of convertible child restraints in relation to Head Injury Criteria using design of experiments.• Worked with GM & Diamler Chrysler focused engineering teams.• Designed airbag fold and inner airbag cover for driver airbag.• Fabricated airbag prototypes and worked with test technicians to carry out design tests as well as required tests for safety• Administrated prototype airbag and seatbelt tests.• Analyzed airbags and seatbelts in post-test disassembly.• Prepared engineering test reports.• Performed quality analysis of side curtain airbag inflator tubes.