First started off as a ATE tester and then progress to a machine operator when my main function was to run the machines and produce PCB’s at a high standard keeping the DPMO low I did this for a few years and started to gain confident and knowledge on the machines and wanted to learn more so I progressed up to a technician level to maintain a good level on the machine and perform preventive maintenance and i am learning more and more each day I have been on a number of machines courses … Show more First started off as a ATE tester and then progress to a machine operator when my main function was to run the machines and produce PCB’s at a high standard keeping the DPMO low I did this for a few years and started to gain confident and knowledge on the machines and wanted to learn more so I progressed up to a technician level to maintain a good level on the machine and perform preventive maintenance and i am learning more and more each day I have been on a number of machines courses Training and qualifcations.• Panasonic MV2F service course.• Universal Inline4/7 Head maintenance. • Universal Lighting Head Course.Knowledge of the following Equipment:Dek 265Dek Horizon 03i and 03i XPanasonic MV2F machineHitachi TIM-5000 MachineHitachi/Sanyo X-200 (4797) MachineHitachi TCM 3500,3000 (4796) MachinesUniversal GSM/GSM-2Universal Advantis Inline 7 MachineUniversal GC-30 MachineUniversal AC-90 MachineUniversal GC-120 MachineUniversal GX-11 Inline 4/7 Machine Vitronics MyReflow OvenSMT OvenSpecialties:Surface mount, SMT machine programmer, screen-printing Show less