Michael A. Cohen (Mac) Email & Phone Number

Kirkland, WA, US

~ Organizes meetings with clients to discuss the scope and magnitude of prospective projects~ Handles creation and modification to all document templates: Quoting, Invoicing, MSA Contracts, SoW Contracts, Change Requests, Expense Reports, etc.~ Engineering Design: Poke-Yoke (Mistake-Proof) Features, Material Selection, Deep-Drawn & Bent Sheet Metals.

Oradell, NJ, US

• Teaches students K-12.
• Addition, Subtraction, Multiplication, Division, Decimals, Geometry, etc.
• Uses various methods to assist students to understand why and how Mathematics are important.
• Instructs various English and reading comprehension skills: Fact gathering, Main Idea, Following Directions, Inferencing, etc.

Birmingham, GB

• (Please see my resume for my accomplishments, these were my responsibilities)
• Designed parts and assemblies, and drafted the drawings in SolidWorks for all of my assigned New-Product Development (NPD) projects.
• Designed derivative products, as well as edited legacy parts and assemblies in CREO 3.0
• Expert DFMEA creation per AIAG 4th edition guidelines.
• Trained coworkers on my FMEA development, in-house manufacturing capabilities, our QMS' documentation standards, and SolidWorks PDM.
• Project Engineer: Design authority over multiple new and legacy products, involving: Calculations, CADD, Simulation, Prototyping, and Validation Test Planning to industry standards (SAE, ASTM, ISO, IEC, etc).

New Port Richey, FL, US

• SolidWorks design/assembly/drafting sheet-metal, machined, and aftermarket hydraulic and electrical parts for R&D projects.
• DFMEA meetings to re-evaluate the next steps in our designs based on failure-mode severity, occurrence, and detection capabilities.
• Fabrication and assembly of sheet metal components/framework, wiring/harnessing, and hydraulic plumbing.
• Electronic Controls packaging and mounting to avoid corrosion and shorts, while increasing serviceability for faster and easier repairs.
• Calculations to ensure structural strength and stability.
• Small component injection molding design for electronic bezel housings.

Largo (Tampa Bay), FL, US

• “Lead Equipment Developer” (Department title for all Engineers and Non-Engineers for procedure/audit purposes) for all assigned projects: Responsible for 15-25 individual projects of varying difficulties at a single.
• Organized all project requirements meetings with clients, paperwork and signatures for starting budgets.
• Design/assembly/drafting in Solid Edge ST5 and ST7 software. Hand-calculations for mechanical stress, electrical designs, and space constraints.
• Design Review(s) with the Model-Makers, Machinists, and clients before finalizing a project's design and drawings.
• Organize and submit spreadsheets of BOMs to purchasing department and management for post-design budget approval.
• Update clients on project status and project timeline for estimated completion dates.

Largo (Tampa Bay), FL, US

• Redesigned factory cell workflows/routines and equipment layouts for multiple service/repair cells.
• Redesigned the global service centers’ training documentation and spreadsheet logistics
• Discovered, initiated, and completed ECR’s/ECO’s for crucial FDA and BSI documentation audits.
• Designed new tools to consolidate space, eventually leading to my promotion into the Tool Room department
• Complete NDT’s on irregular products, resolving issues outside of our technicians’ experience or training to maintain healthy product flow in our factory.

Tampa, Florida, US

* Expressed enthusiasm and utilized my drawing skills to neatly organize problems conceptually and mathematically so that students could succeed in STEM courses.* Calculus I & II & III, Physics I & II, Statics, Mechanics Of Materials, Kinematics & Dynamics, Thermodynamics, Heat Transfer.