Mikael Trigo Da Silva Email & Phone Number

Berne, Switzerland

Corgémont

PCB and FPGA Development

Bern Area, Switzerland

Embedded Hardware Engineer in a wide variety of customer projects FPGA related work :- FPGA development & verification- Netjury (Ethernet Real-time test device) FPGA development of real-time(MAC layer) Ethernet packet generator and analyzer l: http://www.netmodule.com/products/automation/network-test-device.html- PRP & HSR IP core implementation : http://www.netmodule.com/de/technologies/industrial-ethernet/iec62439-IP-core.html - FPGA implementation of the Signal chain of high performance Software Defined Radio (SDR). Modem to extend Ethernet connections over the air-FPGA-Based system for a three axes piezo motion controller for driving Piezoelectric positionersSchematic Project:- Complete development of two compact board (8 layers and 12 layers) for a complete embedded motion controller for piezo positionersOthers:- TI PRU-ICSS programming

Bern Area, Switzerland

Design specification and development of a High-availability Seamless Redundancy (HSR) RedBox (management of the HSR protocol for NON-HSR capable devices in industrial Ethernet redundant network) in a FPGA. Solution as IP Core using VHDL code with Xilinx environment. The main focus was developing efficient data management and finding proper algorithms as to reach timing closure and low resources. Development of test bench for RTL functional simulation.Key words: VHDL, Ethernet, Secure Protocols, MAC, memory management, simulation&verification (VHDL).

At Eia-Fr, Fribourg, Ch

JTAG testing study for the PCB manufactured at the EIA-FR. Creation of a tutorial and a practical work about the software CoFLUENT for the Bachelor students.

Berkeley,Usa

Creation of a benchmark fort studies of high speed data transmission in relation with the ATLAS detector of the large Hadron Collider (LHC). PCB design to accommodate 640 MHz dedicated lines, consideration of potential interference and cross talk effects. FPGA-based processing system using VHDL to run/monitor data through transceivers in order to test a dedicated chip. Creation of a LabVIEW interface (GUI) to send/receive commands with the FPGA.Link: https://webapp.eia-fr.ch/gestionprojets/uploads/2011/B12GE30_TrigoDaSilva_Studies_of_High_Speed_Data_Transmission.pdf

Fribourg

Performing automatic and manual testing on electronic circuits that comes out of production. The mains tasks was to find failure and repair the defective unit in the aeronautics testing department. Improving small test unit.

Fribourg

Analog/numeric electronic design development for the company and for dedicated projects. PCB design using Altium designer (maximum 2 layer), programming microcontrollers PIC, realization of benchmark. Creation from scratch of solar panel which follows the sun in two axes to charge a battery efficiently. The mains tasks were: Project management (along with the mechanical department), schematic creation, PCB design, signal processing, PIC programming, development of efficient algorithm.

Master Of Science (M.Sc.), Embedded System, Electrical, Electronics And Communications Engineering, 5.4/6.0 Average ( 6.0/6.0 For The Master Thesis)

The goal of the Master of Science HES-SO in Engineering (MSE) is to train project managers capable able to develop products and services.

Bachelor Of Applied Science (Basc), Electrical And Electronics Engineering

Exchange Student In Bellingham, Usa, English,Economy Basics,Math And Physics

Federal Certificate Of Capacity, Electronic, Electrical And Electronics

Professional Technical Maturity Certificate