Preparing of PQR, WPS as per standards and project specifications.Carryout inspection activities as per QC procedures. Review of ITP, PQR & WPS as per ASME Section-IX & project material specifications.Conducting of welder qualification test. Experience in fabrication, inspection and Testing of Mounted Bullet.Inspection of incoming materials as per ITP.Reviewing of MPT, DPT & UT Tests.Interpretation of the radiography films for Vessel & piping.Review the PRE HEATING, POST HEATING, PWHT procedure & chat.Ensuring the welding is performing as per approved WPS with qualified welders.Preparing of Grouping weld joints as per WPS wise & Welder wise. Following up of applicable NDT methods after welding.Loop file/test pack review and line walk through to pressure testing.Preparing the reports and verify that records of welding procedure, welding procedure qualification, the welder’s and the welding.Evaluating of test package contents, lines checking against drawing requirements to ensure completeness and accuracy of the piping system.Witness of hydro/ pneumatic test of propane/butane tank, fire water tank, mounded bullets.Weld visual inspection. Assuring proper follow up of WPS during welding. Witness of DP & MP testing, of Inner and Outer cell. Witness of UTG (THICKNESS) Inner, Outer cell and Roof Top plate. Witness of Vacuum Testing Inner and Outer cell. Witness of Metallographic Testing in Inner and Outer cell.Bullet releases for hydro-test. Inspection as per given design, drawing and joint design. Ensuring the welding is performing as per approved WPS with qualified welders. Performing fit-up inspection (misalignment, groove angle, root Opening, preheat requirements etc.) & final inspection of weld joints.