`# Responsibilities involve Vehicle architecture and vehicle Functional requirement analysis, Test case, Test script development, review and execution on the HIL Test bench/Vehicle. Defect Reporting with Root cause analysis and follow-up with counterpart and Suppliers.# End to End Validation of all the possible Body, Chassis and Infotainment telematics ECUs on the HIL Test bench/Vehicle (ECUs worked: BCM, RFHUB, ESL, EPS, ABS, BSM, CSWM, ETM, MSM, TTM, ORC, OCM, DASM, PAM, CVADAS, ECC, ICS, IPC, SCCM, TBM, SGW, HALF, DTV, PLGM, LBSS, RBSS, NVPM, DCSD, WCPM, KINM, CADM, CADM2, ADCAM, MPAD, MPAD2, GNMM, DMSM, DDM, PDM and etcs..)# Validating the Passenger Comfort and Security features (Exterior & Interior Lighting, Passive Entry, Heated&Vented Seat and Heated Steering, Wiper&washer, Power Windows, Power Doors, Power Mirrors, Power Lift Gate, Power Driver and Passenger Seats movement, Memory Seat Management, Climate Controls, Defrost and De-icier, Anti-Theft Alarm) # Validating the Driver safety and ADAS features (Blind Spot Detection, Crash Event safety, Fire Protection Strategy, Parking Assistance, Lane Departure Warning & Assist, Cruise Control, Adaptive Cruise Control, Forward Collision Warning and mitigation, AEBS, TSR, Airbag, Seat Belt reminder and warning)# Experienced in pairing of immobilizer ECUs BCM, RFHM, ESL and ECM to Mechanical key fob or Keyless-go Fobiks in HIL Test Bench/Vehicle.# Validation of Secured On-Board Communication & Diagnostics (Sessions, Security, Read, Write, IO control, Routine, Read DTC and etc…Required UDS services), Fault insertion of applicable DTCs on the ECUs and sensors/actuators [Electrical faults (short to battery, short to ground, open circuit, short to each other), Implausible data DTCs and Loss of Communication DTCs], Self-Healing of faults created.# Validation of Ignition off draw Current (IOD), End of Line (EOL) process verification, Voltage Profiling (Dips and Drops, Brown out) In-Vehicle Network Mgmt.

# BCM, SCCM, RSEM Sub features, DSM and AHUD Functional Requirement analysis.# BCM, SCCM, RSEM Sub features, DSM and AHUD features Test specification preparation.# Hardware requirement analysis for the Test Rack.# HIL Test Bench Configuration and Commissioning support# Test Design for the feature validation scenarios.# Writing the test cases for the test scenarios.# Creating automation test scenarios, Automation desk Sequence, and libraries and validating the same in HIL Rack.# System validation in the test rig with available ECUs and simulated models. # Test result analysis, Issues reporting and documentation

System design, development and validation on CANoe based Vehicle bus simulation,CAPL scripting,In Vehicle Networks(CAN,LIN),ECU Diagnostics validation and dSPACE based BCM Validation,Python Scripting and embedded software development.