Tank Holdings
CurrentStart Machine with 500 Degree Furnace with usually 4 arms , with molds weighing up to usually 500-2,000 pounds, unfortunately mold with ir impact wrench , pour Raw Plastic into mold , cook (cure) in oven for 15-30 min depending on molds cycle time rotation etc. Then arm on machine with mold exits machine , to cooling chamber for usually same time with industrial fans blowing before myself rotational mold operator, un does the mold with a 2 ton chain and pully, impact mechanism. Operator then self extracts the finished part by means of using the rubber mallet,, Pulling mold doors off, and the most extreme humanly possible if it gets cold and stuck if not able tongetbour like mold promptly, which the machine is set by a supervisor that does not even work on the machining platform. the mold usually is 100 degrees when unbolting to release finish product, then within seconds nother Operator with you for 12 hours pours raw plastic in mold from a weighed raw material from a Gaylord that weighs up to 2,500 pounds,and gets filled after each cycle .usually 20lb to 30lb This repeated process is complete when each Order is finalized for each customer or business , then each part is Quality Inspected , completed & ready for shipment in warehouse.
