Nicolas Fromme Email & Phone Number

Bülach, Zurich, Switzerland

St. Gallen, Switzerland

Textile-based joint stabilization device to dampen involuntary movement of hands and arms e.g. tremor

Zürich Und Umgebung, Schweiz

I wrote my master thesis at the Rehabilitation Engineering Lab on the VariLeg project. The VariLeg is an exoskeletons that allow paraplegics to walk again for therapeutic or recreational use. My task is to adapt the variable stiffness actuation module in such a way that it can be used in two modes: variable stiffness actuation mode and conventional stiff actuation mode.

Karlsruhe, Germany

Developing a prosthetic hand for emerging countries

Sindelfingen, Germany

This bachelor thesis deals with a process optimization for the assembly of a vehicle of the Daimler AG. In the assembly the trunk lid must be set under full load in X-, Y- and Z direction. The gap adjustment is made under the workload of the springs and the seal. The initial situation is the partially deficient, cost and rework intensive trunk lid adjustment of all limousines. The task was defined to develop and manufacture a new or optimized adjustment method for the trunk lid assembly of the new A- and B-Class.

Penang, Malaysia

I worked as an industrial trainee for the Engeneering Department of the Car Multimedia Division. I was a member of the Mechanical Design section and a member of the Manufacturing Process (MFI) Team. My scope of work comprised Mechanical Design, Manufacturing Process and other tasks

Essen, Germany

Practical training as an intern in the areas of machining processes, forming processes, thermal joining and separation processes, manufacturing- test- and assembly procedures, assembly and plant construction, gas technology, air technology.

Doctor Of Sciences (Dr. Sc. Eth Zurich), Rehabilitation Robotics

Doctor Of Sciences (Dr. Sc. Eth Zurich)

Research on a Textile-Based Joint Stabilization Device to Dampen Involuntary Movements of Hands like Tremor

Master Of Science (M.Sc.), Mechanical Engineering, 1,6

Activities and Societies: Since 2011 member of the sudent council of the university.Rechnerunterstützte Produkt- und Prozessentwicklung/.

Bachelor Of Engineering (B.Eng.), Mechanical Engineering, 1,9

Activities and Societies: Since 2011 member of the sudent council of the university. Teaching Assistant in Machine Sciences in 2012.