Nik Idzham Email & Phone Number

Federal Territory Of Kuala Lumpur, Malaysia

Johore, Malaysia

Performed capacity study, touch time and cycle time verification for productivity optimization and effective capacity planning.• Maintained and revised process manufacturing flow documents in Job Element Sheet (JES), Standard Operating Procedure (SOP) and Master Process Documents (MPD).• Performed continuous improvement in production line by implementing Kaizen(s),cost reduction analysis and quality improvement initiatives.• Responsible to initiate Process Failure Mode and Effect Analysis (PFMEA) studies.• Support senior engineers to kick off New Product Introduction (NPI) and producttransfer projects at site such as readiness of tools, materials buy-off, SOP preparationand routing set up in SAP.• Performed Failure Analysis (FA) studies by using Fishbones Diagram, 5-whytechniques, and extract data analysis.• Review and monitor equipment efficiency through Overall Equipment Effectiveness(O.E.E) by using Power BI.• Assists senior engineers and technicians to troubleshoot equipment including basicmechanical assembly, hands tools as well as measuring instruments• Assists manufacturing engineering department to maintain and update the latestdocuments, master lists and manufacturing process to comply with ISO:9001:2015.• Assists planning team for capacity improvement projects with manhour capacity, leadtime products as well as Optima routing project.

Selangor, Malaysia

1.In charge for in-coming raw materials (IQC) to eliminate out of specs properties from entering supply chain cycle. 2.Performed in-process quality improvement by working closely on batch adjustments and root cause deficiencies & suggest corrective action.3.Increase productivity by cost reduction project for shelf- life analysis on aged product.4.Prepared test solution and reagents for IQC lab testing. 5.Familiar handling analytical lab instruments such as GC, Karl Fisher, conductivity tester, XRF, pH meter, solid tester and viscometer.6.Assisted for required documentation in Internal Audit for ISO:9001 such as preparing Standard Operating Procedure (SOP).7.Maintaining laboratory instruments calibration, lab consumables and inventories8.Responsible for lab waste disposal and management. 9.Actively participated in 5s, safety huddles and Kaizen for Continuous Improvement Plan.

Klang, Selangor, Malaysia

1) Performed online inspections to monitor the efficiency of the operation and detect any Non-Conformance (NC). 2)Incoming raw material, in-process and product quality control as to comply with ISO:9001, ASTM, HACCP and GMP standard.3)Knowledgeable on CAR and CAPAR4)Support product evaluation accordance to AQL. 5)Established Work Instruction (WI) for IPQC inspections. 6)Defects and root cause & failure analysis (RCA)

Bachelor Of Science - Bs, Engineering Physics/Applied Physics

Foundation In Science, Sciences, 3.33

High School, Science, 7A 2B