High Architectural Glass Manufacturing

● Assisting Production Executive in defects analysis on gloves● Assisting Production Officer and Supervisor in conducting and creating a trainingmanual for training of subordinates and production workers.● Assisting Manager / Assistant Manager in calibration and data analysis on the IBCBULK BOX and BULK TANK● Finding root cause analysis on moisture content (%) on Nitrile Gloves● Analyse the performance of CS COAT (Antitack) in terms of DP% for LINE U1 atMicrosoft Excel by data analysis● Creating a training manual about the design comparison of package burner and palmbrush used for all lines● Created a new palm brush design using Autocad Software( Implementation ofComputer-Aided Design and Solid Modelling)● Assisting Production Manager in creating and updating compounding layout design forFactory 1 and Factory 2 using Microsoft Excel● Proposed a BULK tank latex level measurement ultrasonic sensor project at Factory 1● Daily inspection of production lines, if there is any faulty in machines and gloves if anyproblems must report to Senior Line leader or Production Officer and Executive.● Created a table chart for IBC Bulk Tank verification to determine the relative error % andimplemented Lean Manufacturing and 5S for IBC Bulk Box amount verification● Assisted Production Executive in verifying the checklist prepared for new production LineU13 and updating the new checklist for production Line U13 following StandardOperating Procedures.● I prepared a table of defects found in the gas meter and burner used in all productionlines (U1-U12).● Understanding the daily nitrile /latex Batch ID information sheet in the compoundingsection and update to Manager of Production Department, Mr Harry Fong