Research and DevelopmentLaser Consolidation Additive Manufacturing SystemWorked with the National Research Council of Canada for the development of Novel Directed Energy Deposition technique for additive manufacturing.Responsibilities include:Research on the efficiency and commercial viability of the system.Subsystem analysisHuman Machine InterfaceResponsibilities since September 2020 (DED project put on hold temporarily):Additive Manufacturing Process Design for Space and Aerospace components, for customerssuch as MDA Space, Cobham Ltd, Boeing and Pratt and Whitney Canada.Verifying Test Reports for various parameters such as Tensile, Fatigue, chemistry and Density Tests against customer requirements.Writing process control documents(PCD) for new materials and processesDesigning standard operating procedures

• Automate manual testing done by the hardware team to validate new prototypes and test for compliance with standards and FCC regulations. • Create automated tests of the software-controlled radio (VHF) that can be run in a continuous deployment system • Create new test designs and explore new test areas. • Part of Product Development Team (PDT) • Responsibilities include Design of power measurement tool for P25 software controlled radios.• Experience with RF test equipment including spectrum analyzer, Aeroflex 3920 Digital Radio Set, Signal generator.• Design automatic temperature chamber tests.• Experience with design of calibration tools for Software controlled radios.• Operation of Dual channel RF Repeater system.• Develop and implement automated test procedures to streamline standard RF test functions

• Creation of concept for usage and visualization of multi-touchfunctionality.• Developing GAT template for multi-touch HMI’s of grade VH21.• Adaption of the new operation desktop designs to the existingWinStudio HMI template.• Implementation, test and documentation of the template components.• Porting the same GAT template for VDP15, VDP21, and VEP series.

• Worked in Industrial Automation Department for XLC-MLC SystemTesting and Application.• Part of Indraworks Engineering system test development team.• Worked in Passive Safety Department at Robert Bosch Engineering andBusiness Solutions (Airbags and Antilock Braking systems)• Worked in close association with Drives and Controls, Bosch Rexroth,Lohr am Main, Germany• Aquired new tests on Register controller and Mark stream sensor.• Responsibilities include development test code for Kinematics of threeaxis SCARA Robot Coordinate systems, Energy Management Libraryfunctions (4EE) and test code development for PLC-Open libraryfunction blocks.• Hands-on experience in Development of SCARA Robot and CartesianRobots, including Programming.• Was responsible for initial smoke testing of every suite of IndraworksEngineering.• Experience with Industrial harware set up and test jigs for system testing.• Hands on experience with Industrial communications, SERCOS 2,SERCOS III, Profibus and Ethernet IP.• Experience with analysis of customer reported defects using “5 why’s”method.• Part of the Industrial Intgration/Industrial Automation 4.0 team.