- PPAP submission/approval (FMEA, CP., PSW, GR&R, SPC, Dimensional studies)- Capability studies (cp & cpk) to evaluate consistence of process and product.- Project Launch for new products / Validation of new products- Customer Service / solve technical problems (8D analysis)- Design/Correction of Gauges for Product Inspection- Creation/correction, implementing and training on Standard Operation Procedures for Quality Auditors- Creation/correction, implementing and training on Quality Standards for Quality Auditors- Cost Reduction projects leadership / Introduction and Evaluation of new products- Time Studies for Quality Audits and improvement of audits.- Administration of Calibration program and In-House Verification for Quality Department.

- Time studies to calculate running rate and labor cost. Work Instructions redaction and implementation. Training for group leaders.- Automotive PPAP submission/approval (FMEA, CP., PSW, GR&R, SPC) / IMDS part submission system.- APQP Planning during new products introductions and APQP Annual Review.- Determination of station distribution (floor layout) in manufacturing-assembly area.- Engineering Changes Implementations / New Part Numbers implementations / BOM issue and maintenance / QC inspection procedures- Capability studies (cp & cpk) to evaluate consistence of process and product.- Customer Service / solve technical problems- Design of Fixtures and Poke-yokes for subassembly area (AutoCAD 2006).- SPC and Scrap databases design and maintenance.- Dimensional studies (layouts) on Plastic Parts and Fixtures using a Coordinate Measure Machine (CMM).- Main Database debugging and maintenance (MS Access 2007)- A+ and Network IT basic functions (Cisco networking system).- Incoming Inspection Department - Calibration system administration.- Corrections on CAD drawings (VISI 15) drawings. / AutoCAD rev. 2006- ISO 9000/TS 16949:2009 Internal Audits

- Incoming Inspection Coordinator (SQE functions).- Issuing of main documents for Quality Control and line transference (GR&Rs, FMEA’s, CP)- Giving training curses to all QC Inspectors in both Honeywell plants.- Pursuit and corrective actions with external suppliers.- Direct attention and corrective actions to customer complains- Engineering changes approval. - Support and solving technical problems in lines transferred from USA production lines supervising five people in both shifts.- Design of Fixtures for Quality Inspection using AutoCAD (rev 2006), Line layout record for audits.- Supervision and coordination of 16 quality inspectors.

Engineering Changes ImplementationsPrototypes creation and New Product IntroductionDesign Problem SolvingCustomer complaints solving / 8DISO/QS 9000 implementationTransferring Production Lines from Minnesota to Mexico

Engineering Changes implementationDesign of Production Line Training for Electronic Troubleshooting to Technicians