Delivering warehouse solutions to webshops all over Denmark.

Responsibilities:- Define the scope of responsibilities for this new team- Create of teaming agreements with peers- Hiring of team members for the team (14 TPM’s in total)- Daily management of the team- Define internal processes- Participate in changes in existing processes (Gateway process, Engineering change process etc.)- Improve key challenge areas identified in the team- Setting targets for the team- Budgeting headcount for future

Responsibilities: - Configure all turbine components and handover BOM to project for ordering at SCM- Single point of contact for technical issues on project.- Create plan for, and deliver all deliverables of technical documentation, drawing, work instructions etc.- Ensure answer of sufficient quality to all NC Krimas raised on site.- Provide day-day support to installation crew on site- Participate in customer meetings.- Perform installation manual review- Coordinate project specific development, with DSA’s to TE, or design specifications to local contractor.- Compile As-Build documentation for all installation related documentation.- Review and provide comments on customer deliverables eg, the foundation design.Projects:- Bison IA (15 WTGs)- Keenan 2 (66 WTGs)- Talbot (43 WTGs)- Top of the World (44 WTGs)- Wildorado (34 WTGs)- Windy Flats (39 WTGs)- Mid American (259 WTGs)

Responsibilities:- Design of network infrastructure on all sites worldwide.- Design and implementation of VOIP solutions for offshore sites- Fiberoptic layout for customers without own network team- Develope redundant communication solutions- Develope self-configurable network setup (and got the solution patented)- Support operation of infrastructure on sites, both during installation and after service handover- Vendor qualifications

Responsibilities:- Configure Scada systems for site- Develope, and programmed communication interfaces to Scada (DNP3 protocol)- Create BOM for Scada panels worldwide- Write FAT specifications for Scada systems- Participate in customer test of Scada system- Part of the design team for Turbine Interface Box.

- Work on second and third generation of Turbine Condition Monitoring system. o Maintain BOM for system o Coordinate data harvest o Coordinate all technical contact to vendor- Key coordinator for Scada development towards sub-supplier - Specified, prioritized and tested the development of Scada software

- Work on first generation of Turbine Condition Monitoring system. o Create the BOMs for the material needed in the turbine o Write work instructions for both programming the modules, and installing them in the wind turbine- Participate in customer FAT on Scada systems- I specified, and build a system to record noise from the wind turbines. The system connected the recorded data to the meteorological data present during the recording. The final grade for the project was GPA 4.0