Valaris MS1, shutdown crew- Conduct sea fastening, strengthening of LARS components, and structural fabrication.- Routine maintenance and repairs ensuring quality assurance of work.- Maintain situational awareness and chronic unease in every assignment carried out.- Read and interpret engineering and detailed fabrication drawings.- Setup tools and machinery for fabrication process, including guides, stops and other controls.- Participate in safety meetings, report hazards, risks, near misses and incidents.

Iron Bridge / FMG, 3:1 FIFO- Installation of 900mm 1200mm and 1600mm process water lines.- Flange management inspection and hard torquing of water lines.- Setup and conducted hydro testing of process water lines.- Pipe system layout, configuration and assembly.- Interpreted detailed drawings and blueprints.- Testing of pipe systems for leaks using complex testing equipment.- Training and mentorship of new employees.- Worked cohesively with team members to achieve KPIs.- Followed OHS and isolation procedures to maintain a safe work environment.- Pre-starts, JHA’s, hazard identification, permit to works etc

- Routine maintenance, fault finding and diagnostics.- Maintained and repaired commercial fishing vessels to NSCV 12 Standards.- Ensure allocated work was completed to schedule and met productivity targets.- Focussed on safe work practices and hazard identification.

Gorgon Gas Project, 2:2 FIFO- Construction of the CO2 Injection Module and Train 1 Turnaround Upgrade.- Modification to live systems complying to Chevron 2.0 permit system.- Removal, inspection and replacement of propane refrigerant components.- Supervision and training of new team members.- Liaison with stakeholders to ensure that deliverables were met and adhered to.- Accurate interpretation of isometric diagrams and drawings.

- All aspects of pipe fabrication including welding of piping systems and components.- Assembled and disassembled piping by ways of welding, cutting and/or fitting.- Cleaning flange faces, checking for damage, inspecting worn parts, lubrication and checking flange alignment.- Flange alignment and torquing to ensure a leak-free connection.- Procurement and project coordination including design, testing and regulatory compliance.- Interpreted blueprints to determine locations, quantities and sizes of materials required.

Ichthys LNG Project, 4:1 FIFOLeading Hand Pipefitter / Boilermaker – 4:1 FIFO-Refrigerant piping fabrication and installation, ensuring adequate refrigerant flow and function.- Setup and install hot oil flushing equipment and systems to MR compressor and end flash units.- Monitor and maintain oil flushing equipment and systems when in flushing cycle.- Provide refrigerant, fuel, gas and flare system commissioning.- Inspect and perform flushing procedures to ensure systems are in working order.- Eliminated risks by correctly identifying potential safety hazards.

*Fit-up and installation of LNG tank piping *Adhere to Chevron safety policies and procedures

Seafastening sub-sea pressure testing equipment onboard Mermaid Inscription, Piping maintenance on board the Atwood Falcon, Removal off Subsea pipe testing facility onboard SapuraClough Constructor

Welding and installation of piping and supportsConveyor installation and commisioning

HUC on KTT project

Installation of pipingPressure testing and commissioning of pipelines