• Developed tailored Work packs and Technical & CommercialProposals to meet specific client needs.• Developed NDT & Mechanical Procedure as per Code &Standard• Proficient in industry standards including PTS, ASME, ASTM,ISO 9001, and ISO 17020.• Conducted and ensured compliance during FactoryAcceptance Tests (FAT) with applicable codes and clientspecifications.• Performed thorough verification of vendor documentation toensure alignment with client requirements.• Actively participated in strategic discussions with clients,consultants, and vendors to drive project success.• Achieved a 10% increase in sales, surpassing companytargets through effective client engagement.• Experience in Non-Destructive Testing (NDT) methods,including Phased Array Ultrasonic Testing (PAUT) and Dye-Penetrant Testing (PT), Positive Material Identification (PMI)and Videoscope.• Experience in operating advanced NDT equipment such asMX2, Cobra Scanner, and Jireh Scanner, Olympus IPLEX, PMIXRF.• Monitor all NDT work progress and review all reports anddocumentation as per specification and client requirements.• Designing Calibration and Validation Block according to Codeand Standards• Committed to safety excellence by implementing Safe Manhours, Job Hazard Analysis (JHA), and Job Method Statements(JMS) in compliance with standards and client expectations.Project:1. PROVISION OF PRESSURE VESSEL AND HEATEXCHANGERS INSPECTION, MAINTENANCE AND REPAIRSERVICES FOR IPC MALAYSIA B.V. at FPSO BERTAM(OFFSHORE)2. EPCC OF SAHARA ROSE PROJECT FOR PETRONASCHEMICALS FERTILIZER KEDAH (PCFK)3. DHT X FACTOR PROJECT FOR PENGERANGINTEGRATED COMPLEX (PIC)4. TURNAROUND (TA) 2022 at MALAYSIAN REFININGCOMPANY SND BHD (MRCSB)

• Expert in troubleshooting and resolving complex circuitfailures at both board and system levels.• Skilled in developing comprehensive test, system, and debugprocedures to enhance product reliability.• Proficient in analyzing test data to drive continuousimprovement in test yields.• Regularly generate detailed progress reports and documenttest outcomes for stakeholder review.• Responsible for managing all aspects of RMA products,ensuring efficient debugging and customer satisfaction.

1. Assist technician in jointing and terminating low voltage cable (11kV and 33kV). 2. Installing, upgrading and calibrating meter which is ordinary primary consumer (OPC) and large primary consumer (LPC) 3. Installing earth fault indicator (EFI) at Ring Main Unit (RMU).4. Assist engineer to estimate supply for future project by using Adept software. 5. Assist foreman in switching process at RMU and help to draw single line diagram for Seri Manjung distribution mapping plan for maintenance or breakdown reference.