Muhammad Rizqi Email & Phone Number

Did initial research on a 2.4 GHz high power amplifier (HPA) with for wireless charging application under Ir. B. R. Alam, M.Sc., Ph.D. The amplifier is designed using balanced architecture. Impedance matching networks are designed to meet the optimum source and load impedance for best power-added efficiency (PAE) performance.Output of the research are simulated results (done using Momentum co-simulation) and PCB design files (DXF, Gerber) which can be readily used for PCB manufacturing.

Bandung, West Java, Indonesia

Some R&D work done:- Development of an S-band power amplifier chain and its bias sequence hardware: 15 Watts and 50 Watts amplifiers were implemented while 5 Watts and 500 Watts amplifiers were only designed. Bias sequence circuit consisted of Arduino microcontroller, voltage regulators, current sensors (with ADCs), DACs, inverting op-amps, and BJT-MOSFET-based switches.- VHF low-noise amplifier and mixer: Designed and implemented a low-noise amplifier and a mixer evaluation board for a VHF radio datalink.- Created a simple Arduino program and PCB to control a Yaesu G-5500 rotator-driver intended for antenna measurement application.- Other projects: Involved in a number of other RnD projects, doing RF circuit design, antenna measurements, signal generator measurements, etc.

Does research under Ir. B. R. Alam, M.Sc., Ph.D. on the field of RF engineering. Topics include:- Design and simulation of RF resonators- Design, simulation, implementation and testing of power amplifiers

Worked as an electronics, controls, and telemetry (ECT) staff at the ITB High Altitude Long Endurance Unmanned Aerial Vehicle (ITB HALE UAV) research.- Responsible for tests and implementations of UAV telemetry, RC connection, and video transmission devices- Took part on the testing and installation of various other electrical components of the UAV

Batam, Riau Islands, Indonesia

Works under the Teaching Factory Manufacturing of Electronics (TFME), Politeknik Negeri Batam relating to IoT device development.- Tasked with the integration of sensors, a microcontroller, and a LoRa module to create an Internet of Things (IoT) device.- Programmed the microcontroller, TI MSP430F2132, using Code Composer Studio.- Much involved in the hardware design process : PCB layout/schematics, wirebond connections.

Bachelor Of Engineering - Be, Telecommunications Engineering, 3.81/4.00

Activities and Societies: Aksantara ITB, Ikatan Mahasiswa Telekomunikasi "SIGNUM" ITB, Bengkel Radio IMT "Signum" ITB, Telecommunications.

High School Diploma, Natural Sciences

Activities and Societies: Robotik 28