My professional experience is broad since it has started with R&D and Production Engineer in food industry for about 7 years, than continued with Oil & Gas Industry (both onshore and offshore) including either process design activities or commissining & start-up activities for around 15 years. I was involved in different projects as senior Process & Commissioning Engineer to design new plants, review existing ones, verify equipment, simulation of processes. Recently, I’m involved with the whole workflow of an EPC project, starting from FEED verification through EPC, than up to commissioning and start-up of the new plants with below professional skills:● Process & commissioning manager● Pre-commissioning, commissioning and start-up activities including procedure preparation and verification, inspection, functional tests, FAT, SAT, performance test etc.● Review Contractual Documentation ● Equipment design and verification● Process simulation● Preparation of any kind of process related project documentation (process description, basis of design, Heat&Mass Balance, PFD’s, P&ID’s, MSD’s, equipment data sheet, C&E, operating manual, control narrative etc.) ● Safety tasks (HAZOP, RAM analysis, PSM, SIL, management of change process etc.)● Site survey experiences ● Process control systems such as DCS, ESD, HMI, advanced control, alarm management etc.● Problem solving, trouble shooting and optimization analysis● Interface management with vendors and licensors ● Support for catalyst loading ● Support for development of OTS (Operator Training System) with dynamic simulation test and HMI preparation● Support for development of CMMS (Computerized Maintenance Management System) ● Support for technical alignment of vendors and request for purchase● Support for post order activities● Technical bid evaluation