Rohit Ganesh Email and Phone Number

Current Roles and Responsibilities:1. Equipment Owner for Metals CMP workstations including WCMP; improving overall equipment effectiveness (OEE).2. Equipment Owner for single path critical workstation (FOAK tool); performing eFMEA, deploying predictive maintenance tools and continuous improvement activities: a. Reduced unscheduled downtime by 5% (8 week moving average) in FY2021 b. Enhanced E3 FDC sensor coverage by monitoring >100 new sensors in FY2021 c. Setup of new preventative maintenance procedures and providing training to technician team in FY2021 d. Execution of component/subsystem level improvements toward improving availability. 3. Area FDC system champion; setup and maintenance of fault detection and classification models using E3 FDC system. a. Recognized by management for increasing failure detection model coverage by >10% in FY2021H2.4. Leading deployment of wafer handling diagnostic tool for predictive maintenance of wafer handling systems a. Recognized by management for demonstrating key cost and availability Wins across toolsets in FY2021. Past Responsibilities and Accomplishments:1. Equipment Owner for TW Reclaim CMP Equipment: a. Recognized by director for being part of collaborative effort to increase internal test wafer reclaim process capacity by 40% and generate significant cost savings in 2020H22. Equipment Owner for Oxide CMP workstations3. Area E3 FDC system champion; improved fault detection model coverage by 21% in 2020H24. Total Productive Maintenance Team Leader; leading cross functional team toward Kaizen activities

Executed medium level projects on permanent magnet and induction motor stator manufacturing lines:1. Designed and validated an improved stator end turn gauge to reduce inspection task cycle time.2. Designed, prototyped and fabricated tooling for stator phase lug fixture removal.3. Designed and fabricated stator slot indexing gauge for improved identification of defect location.4. Improved availability of stator wye connector fusing step through root cause analysis of high frequency gripper faults, identified potential solution, performed controlled trials and validated the solution. 5. Used image processing software to analyze and quantify weld void content for fused phase lugs. 6. Investigated and identified cause for bonded stator stack delaminations during robot handling and recommended solutions for the same.7. Design and fabrication of improved mounting system for pneumatic fixed height wire cutters to reduce height drift.8. Installation of light curtains and muting sensors for machine safety zone.9. Set up of Keyence full spectrum sensor for detection of a red color fixture.10. Planned and executed the setup of additional manual stations on the line.11. Made design improvements to existing hand tools for ergonomic purposes.

As a process engineering intern I had the opportunity of working with other process engineers to enhance the painting process of brake pads. The task was to devise an efficient painting fixture to accommodate the large variety of brake pads being painted and ultimately reduce the task cycle time.