Solethu Sinxi Email & Phone Number

Germiston, Gauteng, South Africa

• Optic Fiber Splicing.• Radio Frequency.• Site power cutover.• Site Monitoring and availability using NetEco.• Working at Heights.• Site surveys for new site built.• Halted site PAC, Passive project PAC, L2600 PAC and Generator PAC.• Ensure subcontractors perform according to the laid down specifications.• Ensure that quality is maintained during installation.• Sites fiber link restoration.• Ensure that the site is accepted according to MTN’s acceptance procedures.• Ensure that the implementation projects are done according to required MTN requirements or scope of work.• Ensure that QC standards are met according to laid down specifications.

Hartbeespoort, North-West, South Africa

• Soldering and testing Fibre Optic boards.• Making and testing an RF cable.• Testing a bandpass filter.• Analysis and fault finding of computer/telescope interface boards (assigned cage boards).• Splicing of fibre optic cable.• Vector Network Analyzer Calibration and testing Radome material. • Assist with the installation of an 18 cm receiver in a 26m antenna.• Assist with 16m and 26m Antenna Maintenance.• Dichroic Installation and Removal.• Hardware Interface (RS485 and Digital potentiometer).

Hartbeespoort, North-West, South Africa

Basic Lifting Techniques:• Identify and inspect rigging equipment.• Recall and demonstrate overhead crane hand signals.• Step ladder inspection.• Use of different equipment (Chain block, Shackles D and Bow, Wire rope slings, Chain slings and Tirfor)Introduction to Electronics:• Soldering and De-Soldering electronic components.• Identification and Testing of electronic components using multimeter.• Construction of an electronic circuit on Vero board, Breadboard and PCB.• Testing a circuit using oscilloscope.• Fault finding on an electronic circuit.• Calibration of an Analog and Digital Oscilloscope.Introduction to Electrical Practice:• Identification of different tools and use of tools in Electrical Industry.• Distribution from point of supply to point of control.• Motor testing.• Distribution board wiring.• Drawing and wiring a basic Electrical Circuit.• Conductors, Motors and Staters.• Circuit interpretation and design.• Measuring instruments.• Cable termination and glanding.• PLC and VSDIntroduction to Instrumentation:• Calibration of a transmitter.• Calibration of the controller (DP Cell).• Calibration of control valve.• Feedback control loop.Introduction to Welding practice:• Basic Oxy-acetylene welding and brazing.• Basic shielded metal arc welding.• Basic metal inert gas (MIG) welding.• Basic tungsten inert gas (TIG) welding.

Vanderbijlpark, Gauteng, South Africa

• Regularly contact students to ensure academic, personal and social adjustment.• Mentor and role model positive academic success skills.• Assist students with projects given by the Lecture.