Stephen Sattie Email & Phone Number

• Supported implementation of new process for additional interconnect level to meet customer requirements. Characterized the process, summarized results of experiments and presented the data to senior staff engineers. This process allowed Qimonda to secure a single source contract for a highly valued customer. • Implemented and executed Design of Experiments (DOE) for yield improvement on multiple products. Experiments resulted in achieving department and site goals. • Managed Construction Analysis process to ensure product compliance with stated specifications. •Troubleshot key yield and technology limiters through physical and electrical failure analysis. • Ensured the proper execution of experiments to allow critical process changes to be made on schedule.• Validated desired outcome of process changes after implementation through physical characterization as measured with the Scanning Electron Microscope (SEM)

• Proactively monitored electrical product performance to indentify new fail modes. Coordinated with failure analysis group and product engineers to find root cause of fails. This included use of Advantest and Mos-aid equipment to generate Bit fail maps. • Identified common fail modes across product lots to determine equipment or processes for excursion control. • Lead scrap team for Product Engineering group. Established of root cause for scrap, reassigned scrap material to appropriate area, and initiated corrective action plan for scrap reduction. • Classified material to ensure high quality parts delivered to the customer.

• Managed cross functional team including facilities, equipment engineering, manufacturing and safety organizations. Project consisted of relocation of 15 metrology tools for cycle time optimization and expansion of fabrication layout.• Completed assignment 32 days ahead of schedule.• Advised on equipment location, and routing of new facilities for efficient installation.• Supervised facilities group to shut down all process gases and electrical connections safely. • Coordinated physical relocation of equipment with manufacturing and engineering. • Qualified equipment for production.•Installed, maintained and modified various Photolithography and equipment including TEL Act8 Clean Tracks Canon I line and DUV steppers, and ASML scanners, Hitachi CSEM’s, Tencor measurement tools.

• Repaired and maintained Photolithography equipment including Canon steppers, Nikon steppers, SSI coat and develop tracks, Karl Seuss contact aligners, etc. • Verified device failures using automated and manual test equipment.