Testing and validate the new designed Radio Unit (RRH) and Base Band Unit (BBU)with 3GPP Specification TS 36.141 .Perform the RF system Line up analysis to ensure our system designs meet industry and internal standards.Provides support in the Design, Development and Testing of radio Frequency (RF)system architecture, components, circuits and Products.Installing new setup and Radio Conformance Testing for 4G&5G designed Base Station module as per 3GPP Test documents. Measure and… Show more Testing and validate the new designed Radio Unit (RRH) and Base Band Unit (BBU)with 3GPP Specification TS 36.141 .Perform the RF system Line up analysis to ensure our system designs meet industry and internal standards.Provides support in the Design, Development and Testing of radio Frequency (RF)system architecture, components, circuits and Products.Installing new setup and Radio Conformance Testing for 4G&5G designed Base Station module as per 3GPP Test documents. Measure and Analyzing the RF Transmitter and Receiver parameters like us BS output power, Channel Bandwidth, ACLR, EVM, Spurious Emission, OBUE, Rx Sensitivity, In Band/Out Band Emission and ACS using 3GPP TS 38.141 standard. To test and commissioning the Base band Unit (BBU) as per Radio Units .Validate and Testing the BBU integrated and Sub Module level testing (RF & Traffic Test).Installing the E2E setup for designed RRH and BBU unit to executing the RF and through-put measurements.Working on RF component characterization Lab equipment Vector Network analyzer and Vector Spectrum Analyzer and Signal Generators as per 3GPP TS 38.141 standard Test Specification. Data analysis, exploration and visualization using MATLAB, Linux Terminal, Xilinx Vivado and Adrv R&S Internal tools etc...Provide the RCT Technical Test report documents, process and Procedures.Installs and validates equipment and processes in the production area for new products introduction.Develop and execute test plans, test cases and test setups to verify and validate that products meet radio conformance goals.Carry out RF test execution and generate status and test reports.Perform RF test equipment calibration.To support Automation team and developing ATE (Automated Test Equipment). Show less

DESIGN AND VERIFICATION USING VERILOG