Lead Engineer, design of fire and gas systems to protect petrochemical industries using Det-Tronics fire and gas Equipment, this includes Design of control panels, panel equipment layout, power distribution diagrams, panel module wiring diagrams, load calculations, SAT documents, commissioning procedure documents etc. design of field loops, junction box terminations, system architecture, communication interface, plc programming, setting up Modbus communications between plc and controller, Det-Tronics S3 software configuration for operation of fire protection systems, commissioning of projects and field instrumentation, working according to schedule, budget and required quality. Communicate with project manager, customer and all relevant parties within the project; come up with good engineering solutions. Perform internal factory testing (IFAT), customer factory acceptance testing (CFAT), site acceptance testing (SAT), close and hand over of project to customer and provide support where necessary. Attending tender meetings, site inventory walks to prepare tender quotation information.Supported Fiscal department for four months, Field services, tank gauging for oil and gas depots, tank gauging software setup, perform service level agreements, for Shell, Total, Chevron depots. Etc. Report writing, developing customer relations, commissioning of tank gauging instruments, such as radar, temperature probes, pressure transmitters, foundation Fieldbus interface, and Modbus setup.