Product Validation Manager for consumer, commercial, and industrial projects designed in St. Pete including requirement verification, compliance, EMC, reliability, and validation. Manage multiple verification and validation engineers on multiple projects, human resource projections, budgeting, quoting, requirements management, competency and capabilities assessment, equipment projections. Expertise in UL9540, UL9540A, NFPA855, NFPA69 for Energy Storage Systems, EV Charger Design Compliance UL2202, UL2231,IEC 61851.

– Boeing 787 Dream-liner Lighting System – • Performed Environmental and Power Quality Test on Flight Deck and Exterior Lighting, including Temperature Variation, Fluids, Sand and Dust, Vibe, Mech. Robustness, provided Data Management, set-up Test Equipment, run Test Readiness Reviews, provided conformity, write Quality Test Reports, analyze Hot Re-strike Data

Lead Project Engineer for all FCC Production Hardware for BA609 for which an award was received in recognition of Qual contribution and Customer Presentation:• Managed hardware production meetings,• Established troubleshoot and repair strategy• Technical Customer Interface• Debugged Qual failures, ATP and ESS failures (Temp, Vibe, Humidity, Alt, Salt – Mil-STD-810), • Designed and Implemented Class I and Class II Changes.• Investigation of Obsolescence Components• Performed signal integrity tests • Prepared ROMS, Memorandum of Cost, signal integrity testing.• Designed Analog Circuitry • Team lead on manufacturing of PCB, conformal coat, device topology.

• Test Equipment Engineer on C130-4 Pedal Adjust Actuator, Small Diameter Bomb, ACES 5 Seat Adjustor • Designed and Documented test fixture hardware to test and measure performance.• Designed ATP procedure.

• Lead Production Engineer on EDFLCC F-16 Flight Control Computer• Performed System Diagnostics and board level failure analysis and troubleshoot • Excellent skills with logic analyzer, FET Scope, DVM, Function Gen, etc• Coordinated and performed Board and System Level Repair, Field Service Repairs, Environmental Stress Failure Analysis. • Identified multiple manufacturing defect trends, faulty test and design methods• Performed testability analysis• Designed and Modified Acceptance Test Procedure for LRU, and troubleshoot of any defective units. Provide reports and feedback on issues impacting production, interfacing with Quality and Component Management. • Site Expert in manufacturing and functional testability for all new designs, including implementation of JTAG Boundary Scan, In-Circuit test, Flying Probe, SRU test, and LRU test.• Received Green-Belt Certification in Six Sigma Practices for design of new test process for Graphic Displays.• Presented daily briefings on status of Production Test