Primary Support for Final Test and Laser Handler System in Maxim Batangas Plant• Responsible in yield improvement in final test, resolve issues that affect yield, identify improvement ideas to meet the target yield.• Acquisition to evaluation to buy off qualification of newly acquired machine prior endorsed to production use.• Establish the I-Button Laser system and Test system machine set up in Maxim Batangas, main support for the test and laser system.• Set up, Buy-off and… Show more Primary Support for Final Test and Laser Handler System in Maxim Batangas Plant• Responsible in yield improvement in final test, resolve issues that affect yield, identify improvement ideas to meet the target yield.• Acquisition to evaluation to buy off qualification of newly acquired machine prior endorsed to production use.• Establish the I-Button Laser system and Test system machine set up in Maxim Batangas, main support for the test and laser system.• Set up, Buy-off and qualification of two additional test and laser handler system at Batangas test floor • Lay out and installation of electrical supply of every new machine set up in production floor especially in final test floor• Perform electrical termination, power up to commissioning of new machine set up, buy off and qualification prior endorsing the machine for production run• Coordinate with facilities group in installation of electrical supply, vacuum system needed for every machine set up suggest ideas for improvement.• Perform minor and major breakdown of laser marking handler based on machine electrical diagram • Responsible in the improvement of test and laser handler system to related to set up, machine modification, cycle time and yield improvement.• Resolved machine and process issues by identifying the root cause of the problem by applying the DMAIC problem solving tool.• Update and create Failure Machine Equipment Analysis (FMEA) and process control plan for final test operation. • Provides Temporary Engineering Change Notice (TECN) for evaluation and improvement related in machine and process update the procedure as Engineering Change Notice (ECN) for the permanent change update.• Knowledge in FMEA, 7QC Tools, Basic Statistics, OCAP, SPC, and SASJMP tool process. Show less

• Performs investigation, analysis, troubleshooting, calibration and repair work for each reported equipment problem.• Identify the tools, spare parts needed and prepare purchase requisition or request withdrawal from store and reports abnormal breakages of parts or consumption of spares.• Responsible in sustaining 150 desktop pc units (DELL, IBM, AOPEN, AOC) model per line used for ROM installation and testing.• Responsible for non-periodic maintenance of Japan made equipments used… Show more • Performs investigation, analysis, troubleshooting, calibration and repair work for each reported equipment problem.• Identify the tools, spare parts needed and prepare purchase requisition or request withdrawal from store and reports abnormal breakages of parts or consumption of spares.• Responsible in sustaining 150 desktop pc units (DELL, IBM, AOPEN, AOC) model per line used for ROM installation and testing.• Responsible for non-periodic maintenance of Japan made equipments used for mass production of SMD (Super Multi Drive)-DMD and DVD. Periodic maintenance includes daily, weekly and monthly preventive maintenance routines. Maintenance is focused in eliminating future breakdowns due to long term mechanical wear-outs. Also engaged in changing programs, set-ups and fine tuning especially when machines are producing marginally good units. • Responsible for the repair of defective Pc in line (software / hardware installation of operating system and troubleshooting).• Knowledge in function, operation and troubleshooting of line machines DVD Fringe Alignment, DVD XY Adjust Machine, Normal / Hot Aging Machine, Media Tester with PC controlled. Show less