Vincent Robichaud Email & Phone Number

Tokyo, Japan

-Perform daily coordination of technical support activities and repairs operations-Give technical support to colleagues, resellers and customers-Perform troubleshooting on Creaform technologies to find root cause and solutions.-Provide internal technical trainings.-Develop and update the technical knowledge base with the other Experts.-Collaborate in the evolution of repair techniques and tools-Supervise maintenance process-Perform repairs, calibrations, and certifications of Creaform systems-Oversee inventory management processes

Japan

Start-up of Creaform repair center for APAC territories. Situated in Japan, this center is responsible for the repairs and calibrations of Creaform 3D scanners. • Setup of the repair center installation• Implementation of repair and calibration processes• Collaborate in the evolution of repair techniques and tools• Supervise maintenance process• Analysis of the symptoms related to defective equipment• Perform repairs, calibrations and certifications of Creaform products• Provide consulting expertise to technical support team• Oversee inventory management processes;

Tokushima, Japan

As a leader of the R&D team, I worked on the design and development of new products for the semiconductor industry. Main activities include new developments related to wafer mapping systems and in-situ monitoring systems for wafer process control. I was dealing with systems requiring good knowledge in optical metrology, sensor data acquisition, laser, embedded system, software design, and algorithms development. From customer’s requirements, we were proposing and realizing complex systems where I was actively involved in in the following tasks: • Customer requirements analysis• Translating customers’ requirements into system requirements• Participate to systems design (systems architecture, components, interfaces, data)• Rapid prototyping to simulate and validate new concepts• Software applications development (multi-thread C++ MFC application). • Test, validation, debugging and performances optimization of the system • Test, debug and validation of the electronics development by the R&D team• Driver development to interface hardware with application software • Embedded firmware development (C/C++)• Article redaction• User’s manual redaction• Development of algorithms for real-time data analysis.

France & Canada

Managing projects related to optical devices allowing non-invasive in-vivo imaging on small animals. Main achievement is the realization of the optical QOS™ scanner, an optical (fluorescence / bioluminescence) scanner dedicated for the pre-clinical imaging. Below is a list of the tasks accomplished: • Translate functional needs of biologists into technical solutions• Design of imaging systems• Optical conception of imaging systems• Development of motion control system (PLC programming)• Development of an algorithm to move the camera to the same position over the animal between each session.• Team coordination, time management, negotiations with suppliers, budgeting• Evaluation and compliance of UL standards

Canada

Assisting students during laboratory sessions dealing with the interfacing and programming of microcontrollers (PIC, DSP). Main objective was to teach basic notions of digital signal processing using a platform based on the DSP “TMS320C5402” of Texas Instruments.

M.Sc.A., Electrical Engineering, Medical Imaging

My Master’s degree project has been related to non-contact diffuse optical tomography, and has consisted of: 1. Design and development.

B.Ing., Electrical Engineering, Electrical Engineering

For the last two semesters of my Baccalaureate in electrical engineering, I have studied the Micro-Bioengineering specialty, which.