刘秋实 Email & Phone Number

中国 山东省 烟台

Job description: Electrical work pack preparation as commissioning procedure. Attend handover walk down from CKJV construction side. Carry out commissioning job following work pack and procedure with punches cleared. Issue work permit, confirm isolation certification and conduct zero energy verification. Finishing all check sheets. Organizing hand back walk down to construction side when commissioning job finished.1.E-house in module livening up. 2.Motor protector simocode parameter setting and loop test to CCR, motor cables checking and motor solo run. 3.Equipment in E house energization (HVAC, Fire alarm system, annunciator panel, UPS).4.Heat tracing panel and heat tracing line energization. Parameter setting and conduct IR test, function test.5.Lighting system in module energization.

中国 山东省

Job description：Charging the electrical commissioning of new handing over chemical plants, making sure up to standard of start-up. Also charging the maintenance work after plant operation and overhaul in Chemical plant shutdown period.1.LV MCC motor protector function test, motor solo run, operating for water trial. Frequency convert parameter setting, Interlock signal and command signal, feedback signal checking. MV VFD protection test, loop test, motor solo run and load test, curve recorded.2.Heat trace line checking, IR test and energization. Lighting system energization.3.Extrude and pelletizer system commissioning and electrical heating energization.

中国 山东省

Mainly charging the power system of the drilling rigs,1.Generators winding IR test and high potential test, temperature protection, LO flow and pressure signal checking and loop test. 2.MV switchboard relay parameter setting and function test, interlock signal checking and loop test. Bus-bar high potential testing, termination toque checking, starting generator and MV switchboard energization.3.LV switchboard relay and MCC protector setting. Bus bar and transformer toque check, IR test, micro-ohm test, transformer ratio and high potential testing, energizing switchboard. Power cable and communication cable termination, withdrawable MCC feeder and VFD function test, loop test.4.Generator set parallel operation and load test.5.Organizing official test and loop test to owner, clearing the punch list. Being in coordination with other system to control the progress of the project, and ensuring that the project is delivered on time.