PreCOOLING

PreCooling offers innovative solutions to increase the efficiency of the process of adiabatic air-cooling systems - PreCooling. In addition to the increase of efficiency of the cooling capacity, this technology allows to significantly save the electrical energy consumed during operation of the cooling and air conditioning equipment and to ensure longer service life of the equipment as well. PreCooling Panel is installed before air conditioning and refrigeration equipment condenser for the cooling system. By use of the special technology of PreCooling, the system sprays fine mist of water creating a fog effect, which causes evaporation in the air drastically reducing the temperature of the inlet air in the condenser in an adiabatic process. In contact with warm air a certain amount of water evapora tes and as a result of the energy exchange the air temperature drops dramatically (approximately 10-20 ° C), which allows consumtion of less electric energy to provide the required temperature. To further lower the intake of air temperature, the special membranes are used, which block the effects of the direct sunlight on the condenser and keep it clean. The total electricity savings can reach up to 41%. In contact with warm air a certain amount of water evapora tes and as a result of the energy exchange the air temperature drops dramatically (approximately 10-20 ° C), which allows consumtion of less electric energy to provide the required temperature. To further lower the intake of air temperature, the special membranes are used, which block the effects of the direct sunlight on the c The Adiabatic systems PreCooling consists of the following parts: Pump unit Control panel to enable automatic operation of the system Water treatment system Panels with sunlight reflecting and inlet air filtration membranes Water-spray nozzle system PreCoolin system is equipped with a UV (Ultra Violet) lamps that eliminate the formation of Legionella bacteria and other bacteria in water