Deo Selosa Email & Phone Number

Pinjar, Western Australia, Australia

• Controls 6 - Frame 6 and 3 - Frame 9 Gas Turbine @ Pinjar Power Station – through SCADA Ignition
• Controls 2 HEGT Kwinana Power Station – through SCADA Ignition / Cimplicity
• Controls 2 Kemerton Power Station
• KBESS – 1 (Kwinana Battery Energy Storage System) Control
• Monitors and adjust Voltage of Gas Turbine Units; MVAR, MW
• Performs MCR testing of Frame 6 and Frame 9 units as per AEMO and Synergy’s asset

Perth, Australia

Ravensthorpe, Western Australia, Australia

• Process Controller for the utilities which consists of three 18.5 MW Steam Turbine, Three Diesel Fired Boilers, Ten 2.2 MW Diesel Generators and Sulphuric Acid Plant
• DCS Operations via Emerson DeltaV
• Ensure safe, efficient and reliable operation of the Power Plant and Sulphuric Acid Plant
• Promptly respond to plant interruptions and escalates issue to Shift Supervisor/Superintendent and Process Coordinator
• Participate in investigation and root cause analysis of safety, quality and reliability issues and incidents
• Monitor Plant performance and check for malfunctions, leaks and other faults; report issues to Supervisor promptly

Ravensthorpe, Western Australia, Australia

• Recommissioning of process utilities of the Ravensthorpe Nickel Operations
• Process Controller for Utilities which consists of Three 18.5 MW Steam Turbine, Three diesel fired Boilers, 10 2MW Diesel Generator and Sulphuric Acid Plant
• Emerson DeltaV DCS
• Ensure safe, efficient and reliable operation of the Power Plant and Sulphuric Acid Plant
• Promptly respond to plant interruptions and escalates issue to Plant Manager
• Participate in investigation and root cause analysis of safety, quality and reliability issues and incidents

North Fremantle, Western Australia

• Manage routine operation of process, systems and equipment in a designated area
• Follow routine procedures and initiate correct methods of developing non-routine procedures
• Manage safe work including the issue of permits as an area authority under the work permit system
• Ensure plant integrity is maintained by vigilant monitoring of equipment
• Liaise with Maintenance team and advise of any abnormal performance or potential failure of equipment
• Maintain required competencies for the safe and efficient operation of plant

Port Hedland, Western Australia

• Process Operations of Ammonium Nitrate Emulsion Plant; both DCS and Field Operations thru CITECT
• Carry out sampling of Ammonium Nitrate Emulsion; pH and crystallization point
• Carry out JSERA and Red Books PM
• Unloading of Ammonium Nitrate Solution, Acetic Acid
• Package Boiler Operations and Maintenance
• Forklift Operations

Canning Vale, Western Australia

Shenton Park, Western Australia

• Duties:
• Leading hand for process operators across plant operations including Start up and shut down activities, fault finding, and General Cleaning of various locations of the plant; including unblocking of drains
• Process Operation of Advance Waste Technology through DCS (800 XA ABB)
• Carrying out process isolations as directed and in accordance with the PTW System
• Acting as a member of the Incident response team as required by current procedures
• Procedure Development, Log sheet, emergency procedure

Perth, Western Australia

• Carry out a broad range of utilities and forklift operation duties around a busy laundry operation whilst ensuring all work is completed with the highest regard for all safety procedures and controls.

Rabigh, Kingdom Of Saudi Arabia

• 600 MW Steam Power Plant (5 120 MW Steam Turbine and 9 Boilers)
• Led, managed and supervised a crew of 15 operators across plant operations which included but was not limited to activities such as faultfinding, shutdowns, startups, isolations and service/maintenance activities.
• Perform Voltage/Frequency adjustment as per operational procedure. Monitor 110 kV GIS Substation as per power requirement of Petro Rabigh Refinery.
• Ensured all operations within the plant ran and operated according to plans (shutdown/startup times) and specifications. These areas included boiler, generator and load switching.
• Carrying out process isolations as directed and in accordance with the PTW System
• Utilized CMMS to create, revise and complete Work Orders and Work Specifications

Rabigh, Kingdom Of Saudi Arabia

• Coordinates with planning, technical services and maintenance department on testing and inspection time frame
• Coordinates with client on time frame of Testing and Inspection
• Developed Block Isolation of Power Plant equipment Key Achievements
• Developed Isolation Procedures for various Power Plant equipment; including Block Isolations of Boilers, Feed Pumps, Flue Gas Desulphurization Plant, Switch Gears
• Time Table for the Testing and Inspection of Equipment done with no delays
• Re-started the Power Plant with 3 days before agreed date

Rabigh, Kingdom Of Saudi Arabia

Region IVA - Calabarzon, Philippines

Established QA/QC system and applied ISO 9001 series 2000 through a series of Quality Audit in both Maintenance Section, Adhesive and Heat Press Section.Only Section Leader that handles three sections (Maintenance, Heat Press and Molding Section) in one year of service

Master Of Business Administration - Mba

Bachelor Of Science - Bs, Mechanical Engineering, 85

Activities and Societies: Student Council

Certificate Iv In Process Plant Technology, Chemical Process Technology