Over 6 years data communication equipment development experience on driver/BSP/Network processor/TCAM/Switch/MAC/PHY in international companySolid experience with C, C++, Intel IXP & EZchip microcode and assembly language for PowerPCFamiliar with EZchip NP3C & NP4C, Intel 1200/2400/2800 series NP architecture, Broadcom BCM series & Marvell switch and PHY architecture and SDK softwareFamiliar with Netlogic TCAM HW structure & SW SDK, such as NL6K, NL7K, NL11K.Familiar with mechanism of CAN bus, 1G/10G PHY, SFP/XFP, temp sensor; LED, etc.Familiar with PCI, GPIO, I2C, XAUI, GMII/SGMII, DDR, interlaken interfaces etc.Experience on Vxworks based BSP development, boot loader, application like TFTP development experience on QNX and Linux environmentSolid experience on diagnostic software development, data path & static test design and implementFamiliar with L2/L3 forwarding, TCP/IP protocols, IPv6 and MPLS and QosFamiliar with test equipments like Smartbits, IXIAStrong ability in new board bring up and ASIC verificationStrong analytical ability and problem solving skillsGood oral and speaking English, overseas work experience
Listed skills include Cisco.