1. Full in charge of all mentioned responsibility in previous position in M.P.K CO and IRISL as Chief Electrical Engineer (ETO).2. Full in charge of Dynamic Positioning (DP) system as Dynamic Positioning Maintenance (DPM) In DP1 vessel (Caspian 2) including:- DP system such as DP panel, operator station, operator station cabinet, sensors, reference systems, thrusters and etc.- Maintenance, testing, faultfinding, and repairing of all above mentioned equipments.

Chief Electronic Engineer (ETO) and DPM on a DP vessel.1. Full in charge of Dynamic Positioning system(DP),electrical, electronic, control, communication, hydraulic and pneumatic machinery including: -Communication system such as: RADAR, GPS, GMDSS, AIS, VDR, ECDIS, INMARSAT. -Engine room machinery such as: generator, main engine, refrigeration System, air condition system, alarm monitoring system, main and emergency switch board, distribution panels and different type of electrical sensors. -Deck machinery such as: deck and provision cranes, mooring winch, windlass, hatch cover, and etc. 2.Maintenance, testing, fault finding and repairing all above mentioned machinery.3.Follow the plan maintenance program of machinery according to the schedule in order to reducing damage, defect, unaccustomed stoppage.Competent to perform the functions as following below:1.Navigation2.Cargo handling3.Controlling the operations of the ship and care for person on board4.Marine engineering5.Electrical, electronic and control engineering6.Maintenance and repairing7.Radio communications

Full in charge of Electrical, electronic, control, communication, hydraulic and pneumatic machinery in bridge, deck, engine room & control room.Maintenance, testing, fault finding and repairing all above mentioned machinery.Supervising and controlling of operation and management of engaged staff in operation.

1. Planning and designing of industrial system (Construction) 2. Responsible for drawing up installation plans for commercial property power supplies. 3. Designing and calculation of both power and control circuits and their cabinet panels, cabling, power supply systems and etc. 4. Preparing of their components and equipment, Supervision of assembling, installation, starting and testing of system.5. Supervising of engaged staff during project.6. Installation and starting of machinery.7. Preparation of reports at planning and installation stages.